AutosTalk Forums  

2003 Avalanche stalls at low speed when firmly applying brake.

4x4 Chevy/GMC Trucks 4x4 Chevy/GMC Trucks Discussions (alt.autos.4x4.chevy-trucks)


Discuss 2003 Avalanche stalls at low speed when firmly applying brake. in the 4x4 Chevy/GMC Trucks forum.



Reply
 
Thread Tools Display Modes
  #1  
Old   
Furnace
 
Posts: n/a

Default 2003 Avalanche stalls at low speed when firmly applying brake. - 02-07-2009 , 02:10 AM






Hi there,

2003 Avalanche
191,000Kms
5.3L
4x4

When I am driving at low speed and lets say I turn sharply and apply the
brake to enter a parking spot or to stop and back up, the vehicle will
stall. It will start up right away all the time after this happens. As well
I notice that when I am at a stop light the truck will idle real low and the
volt meter will go way down and the lights will dim until I step on the gas
to accelerate. Same happens when I run the defroster or the A/C.

Any Ideas?

thx,

BG.



Reply With Quote
  #2  
Old   
Desertphile
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-07-2009 , 02:53 AM






On Sat, 7 Feb 2009 01:10:02 -0600, "Furnace"
<furnace44 (AT) sasktel (DOT) net> wrote:

Quote:
Hi there,

2003 Avalanche
191,000Kms
5.3L
4x4

When I am driving at low speed and lets say I turn sharply and apply the
brake to enter a parking spot or to stop and back up, the vehicle will
stall. It will start up right away all the time after this happens. As well
I notice that when I am at a stop light the truck will idle real low and the
volt meter will go way down and the lights will dim until I step on the gas
to accelerate. Same happens when I run the defroster or the A/C.

Any Ideas?
Hi! It's a vacuum leak, most likely. Some times the vacuum hoses
are cracked and they don't look like it; some times the oil fill
cap is allowing air to be sucked in; some times the air intake
hose (duct) is cracked and allowing air in. That is the "easiest"
thing to check. If the hoses are good, it could be a stuck PCV
(positive crankcase valve).

On my Toyota the air intake hose was split underneith where it was
not visible, and the vehicle was doing exactly what you described
above. I patched it with duct tape, bailing wire, and more duct
tape because I'm poor white trailer trash, and it solved the
problem.


Quote:
thx,
BG.


--
http://desertphile.org
Desertphile's Desert Soliloquy. WARNING: view with plenty of water
"Why aren't resurrections from the dead noteworthy?" -- Jim Rutz


Reply With Quote
  #3  
Old   
Augustus
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-07-2009 , 12:41 PM




"Desertphile" <desertphile (AT) invalid-address (DOT) net> wrote

Quote:
On Sat, 7 Feb 2009 01:10:02 -0600, "Furnace"
furnace44 (AT) sasktel (DOT) net> wrote:

Hi there,

2003 Avalanche
191,000Kms
5.3L
4x4

When I am driving at low speed and lets say I turn sharply and apply the
brake to enter a parking spot or to stop and back up, the vehicle will
stall. It will start up right away all the time after this happens. As
well
I notice that when I am at a stop light the truck will idle real low and
the
volt meter will go way down and the lights will dim until I step on the
gas
to accelerate. Same happens when I run the defroster or the A/C.

Any Ideas?

Hi! It's a vacuum leak, most likely. Some times the vacuum hoses
are cracked and they don't look like it; some times the oil fill
cap is allowing air to be sucked in; some times the air intake
hose (duct) is cracked and allowing air in. That is the "easiest"
thing to check. If the hoses are good, it could be a stuck PCV
(positive crankcase valve).

That's unlikely to be the cause, vacuum leaks tend to increase the idle, not
decrease it.
This is more likely the cause.......
http://www.automotivehelper.com/topic210522.htm
Along with that, as a matter of course he should pull any stored codes with
an OBDII reader and see what's there.




Reply With Quote
  #4  
Old   
Desertphile
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-07-2009 , 06:57 PM



On Sat, 07 Feb 2009 17:41:30 GMT, "Augustus" <no_one (AT) nowhere (DOT) net>
wrote:


Quote:
"Desertphile" <desertphile (AT) invalid-address (DOT) net> wrote in message
news:g0fqo4d9k43h7930dtdj2g093ts68e1eqg (AT) 4ax (DOT) com...

On Sat, 7 Feb 2009 01:10:02 -0600, "Furnace"
furnace44 (AT) sasktel (DOT) net> wrote:

Hi there,

2003 Avalanche
191,000Kms
5.3L
4x4

When I am driving at low speed and lets say I turn sharply and apply the
brake to enter a parking spot or to stop and back up, the vehicle will
stall. It will start up right away all the time after this happens. As
well
I notice that when I am at a stop light the truck will idle real low and
the
volt meter will go way down and the lights will dim until I step on the
gas
to accelerate. Same happens when I run the defroster or the A/C.

Any Ideas?

Hi! It's a vacuum leak, most likely. Some times the vacuum hoses
are cracked and they don't look like it; some times the oil fill
cap is allowing air to be sucked in; some times the air intake
hose (duct) is cracked and allowing air in. That is the "easiest"
thing to check. If the hoses are good, it could be a stuck PCV
(positive crankcase valve).

That's unlikely to be the cause, vacuum leaks tend to increase the idle, not
decrease it.
Uh, it is an obsewrved fact that a vacuum leak can cause low idle
and stalling when the vehicle comes to rest.

Please do the following test: start your vehicle's engine (if you
have one) and get it up to operating temperature; then unscrew the
oil fill cap and remove it. Or disconnect the air intake hose.


Quote:
This is more likely the cause.......
http://www.automotivehelper.com/topic210522.htm
Along with that, as a matter of course he should pull any stored codes with
an OBDII reader and see what's there.


--
http://desertphile.org
Desertphile's Desert Soliloquy. WARNING: view with plenty of water
"Why aren't resurrections from the dead noteworthy?" -- Jim Rutz


Reply With Quote
  #5  
Old   
Augustus
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-07-2009 , 07:23 PM




Quote:
Uh, it is an obsewrved fact that a vacuum leak can cause low idle
and stalling when the vehicle comes to rest.

Please do the following test: start your vehicle's engine (if you
have one) and get it up to operating temperature; then unscrew the
oil fill cap and remove it. Or disconnect the air intake hose.
An unusually high idle is indicative of a vacuum leak. This is pretty
common knowledge....pull offyour PCV hose and see what happens if you
don't believe me..


Reply With Quote
  #6  
Old   
Desertphile
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-08-2009 , 07:16 PM



On Sun, 08 Feb 2009 00:23:45 GMT, Augustus <no_one (AT) nowhere (DOT) net>
wrote:

Quote:
Uh, it is an obsewrved fact that a vacuum leak can cause low idle
and stalling when the vehicle comes to rest.

Please do the following test: start your vehicle's engine (if you
have one) and get it up to operating temperature; then unscrew the
oil fill cap and remove it. Or disconnect the air intake hose.

An unusually high idle is indicative of a vacuum leak. This is pretty
common knowledge....pull offyour PCV hose and see what happens if you
don't believe me..
Did you do the test I suggested? If you did you will have
discovered the engine idle speed will decrease. This is also true
for a bad air intake hose and other vacuum hoses.


--
http://desertphile.org
Desertphile's Desert Soliloquy. WARNING: view with plenty of water
"Why aren't resurrections from the dead noteworthy?" -- Jim Rutz


Reply With Quote
  #7  
Old   
Augustus
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-08-2009 , 09:38 PM




Quote:
Did you do the test I suggested? If you did you will have
discovered the engine idle speed will decrease. This is also true
for a bad air intake hose and other vacuum hoses.

Did you do the test I suggested?


Reply With Quote
  #8  
Old   
Augustus
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-08-2009 , 09:39 PM




Quote:
Did you do the test I suggested? If you did you will have
discovered the engine idle speed will decrease. This is also true
for a bad air intake hose and other vacuum hoses.
Did you do the test I suggested as well?


Reply With Quote
  #9  
Old   
Furnace
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-09-2009 , 12:42 PM



Not yet.

"Augustus" <noone (AT) nowhere (DOT) net> wrote

Quote:
Did you do the test I suggested? If you did you will have
discovered the engine idle speed will decrease. This is also true
for a bad air intake hose and other vacuum hoses.

Did you do the test I suggested as well?



Reply With Quote
  #10  
Old   
Desertphile
 
Posts: n/a

Default Re: 2003 Avalanche stalls at low speed when firmly applying brake. - 02-09-2009 , 08:08 PM



"Augustus" <noone (AT) nowhere (DOT) net> wrote


Quote:
Did you do the test I suggested? If you did you will have
discovered the engine idle speed will decrease. This is also true
for a bad air intake hose and other vacuum hoses.

Did you do the test I suggested as well?
Dear idiot,

Giving people wrong advice is not doing them a favor.


--
http://desertphile.org
Desertphile's Desert Soliloquy. WARNING: view with plenty of water
"Why aren't resurrections from the dead noteworthy?" -- Jim Rutz


Reply With Quote
Reply




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Powered by vBulletin
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.