anyone know what size extractor to use to get a broken stud out of my
tranny? went to change the fluid out and busted one of the heads right off
clean. I figure I just have to centerpunch the stud and drill it and then
try and extract it. Only problem is I don't know off the top of my head what
size bolts they used in there.

Best bet is to get an extractor set from a parts store! The bolts are a
metric equivalent of 1/4inch. It would probably be an 1/8inch ectractor at
the largest.



"Cheryl and Rob" <craftingpa (AT) verizon (DOT) net> wrote

oil pan bolt ?

M-8 x 1.25

if only one is bad, try it as-is

I've seen 'em with several broken and it don't leak


"Cheryl and Rob" <craftingpa (AT) verizon (DOT) net> wrote