Can someone either give me a link or briefly 'splain how to pull the p/s
pump? I've got the puller set. There does not seem to be a nut holding
the pulley on.
Thx
Mike

Mike Copeland wrote:
If you have the puller set it should have directions. The pulley is a
press fit and pulls off.
If you have the multi piece puller -
There should be a set of puller collars, a ring that fits around them
and the puller sleeve and screw.
The sleeve screws onto the puller screw. Then the collars get set into
the groove on the pulley and the groove on the sleeve. The locking ring
goes over the entire mess and when you tighten the puller screw it pulls
the pulley off the shaft.

If you have the puller that looks like a two jaw it just locks into the
groove and you tighten it down.

If you have the other style one piece puller it slips over the pulley in
the slot and you tighten it down to pull the pulley.




--
Steve W.