| | Rating Thread /
Thread Starter | Last Post  | Replies | Views |
|  | 1997 GMC Yukon 5.7L 2WD
I just replaced my leaking intake manifold gaskets, went to start it
and it runs like crap (surges between 500 and 2000 rpm...
Larry
|
04-16-2006 08:12 PM
scrapir | 3 | 17 |
|  | brake lights stuck on. even when truck is shut off. where would the problem
be found? could it be even because of a burnt bulb - i don't think so,...
derekpigeon1 via CarKB.com
|
04-16-2006 06:48 PM
sparkie | 2 | 14 |
|  | Jimmy 2001 SLE 51,000 miles.
I have what seems to be a very minor oil leak.
The shop said the oil lines are bad and this is a very common problem...
dbltap
|
04-16-2006 06:13 PM
SnoMan | 2 | 13 |
|  | somebody wrote:
means your Spark plugs are not accepting all the voltage/amps...
poor quality plugs..
I used to get this problem with my 89 s-10...
siveman via CarKB.com
|
04-16-2006 01:11 PM
David Johnson | 2 | 8 |
|  | ihave 90 chevy suburban 350 fully loaded startes runs few minutes then dies
no fault codes in computer driving me nuts
choochoo
|
04-16-2006 12:59 PM
SnoMan | 4 | 7 |
|  | 1992 s-10 4.3 auto air tilt wheel
Hey all heres a wierd one. The gear selector is stuck in park and the ign
key wont come out of the lock. At first...
seeray28\(steve\)
|
04-16-2006 05:14 AM
Grumpy13 | 12 | 13 |
|  | seeing that I'm on a roll tonight....
just thought I would make mention of a place to check out for car &
truck parts on the web.......
Elbert
|
04-15-2006 11:33 PM
Elbert | 0 | 9 |
|  | When Isuzu first started selling their Isuzu tiltcab with the 3.9 diesel, my
Chevy truch dealer sold them. Then they came out with the Isuzu tiltcab...
stillrolling
|
04-15-2006 11:27 PM
Elbert | 1 | 6 |
|  | Question on a 92 K 1500 Chevy. Pickup 5.7, auto trans.
Does anyone know if the auxiliary electric radiator fan only came on
the 3/4 & 1 tons or...
Elbert
|
04-15-2006 10:36 PM
Elbert | 0 | 10 |
|  | How do I adjust the front drivers door. It seems the bottom pin thru
the hinge has too much play allowing the door to drop approx 1/2 inch
when not...
Slats
|
04-15-2006 04:42 PM
Shep | 1 | 10 |
|  | How do I adjust the front drivers door. It seems the bottom pin thru
the hinge has too much play allowing the door to drop approx 1/2 inch
when not...
Slats
|
04-15-2006 12:17 PM
Slats | 0 | 11 |
|  | Does anybody here know who has grave digger (or gravedigger) mousepads?
Somebody had them on ebay, but now I don't seen them anymore.
Please send me...
ylimahl@hotmail.com
|
04-15-2006 04:21 AM
ylimahl@hotmail.com | 0 | 7 |
|  | thinking of getting a 1999-2002 ZR2. are these fairly reliable & is
there something special i should be checking for when i look at some?
thanks......
Lee Jordan
|
04-14-2006 09:57 PM
Bill Gee | 1 | 7 |
|  | I am having problems with my 86 Chevy Silverado 2wd pk-up. The problem is
that the starter won't crank. When I turn on the key, I can hear...
Jester
|
04-14-2006 08:22 PM | 2 | 8 |
|  | After reading about people with much the same problem, I was wondering if
someone could tell me where to find the "brake switch" in this truck. ...
derekpigeon1 via CarKB.com
|
04-14-2006 11:27 AM
Jonathan | 1 | 11 |
|  | My son recently bought a 95 Silverado and although it's a cherry truck,
we can't seem to get the cruise to work. Where should I be looking to
find...
Paco
|
04-14-2006 09:34 AM
Paco | 0 | 8 |
|  | Can these be repaired if the tanks start leaking? I'm not positive the
Plastic tanks can be resealed to the core. What is the best route to take
as...
philc37388
|
04-14-2006 12:00 AM
philc37388 | 4 | 10 |
|  | Can you give me any guidence on how to remove it?
DRW
drw170@yahoo.com
|
04-13-2006 04:25 PM
drw170@yahoo.com | 7 | 10 |
|  | I have a 98 Blazer that is having some problems. I have been told that
the problem is probably the transfer case motor. Can anyone tell me
how to...
drw170@yahoo.com
|
04-13-2006 03:51 PM
drw170@yahoo.com | 0 | 17 |
|  | Ordering some new wheels tomorrow. They offer a hub centric version and
also a lug centric version. Do I need to order hub centric wheels for
my...
carlahomolka@hotmail.com
|
04-13-2006 09:37 AM
The Nolalu Barn Owl | 2 | 14 |
|  | This truck still will not start. It now has a new pickup coil, control
modual, coil, cap & rotor, computer, ignition switch. I have been through
a...
Grumpy13
|
04-12-2006 10:13 PM
Grumpy13 | 0 | 15 |
|  | i have 1984 c10 with 305, replaced timing chain new valve cover gaskets new timing cover now truck wont start, timing marks matched
up distributor...
Mark Miller
|
04-12-2006 10:03 PM
Shades | 5 | 9 |
|  | I have a 99 silverado 1500 2wd and I was looking at the 7" pro comp
crossmember system, has anyone used this kit or lifted their silverado
and had...
D213
|
04-12-2006 07:29 PM
D213 | 0 | 11 |
|  | 2005 Chev Colorado
Does anyone know how to program extra key fob
have original 2 bought a new one from ebay need
help
Thanking you in...
Mathehun
|
04-12-2006 02:17 PM
Mathehun | 0 | 14 |
|  | I have a 2001 chevy Z71 1500, I hear a clunking noise when I accelerate
from a stop, also when I pull my race trailer it feels rather odd in
that...
mxracr
|
04-12-2006 12:14 PM
genius@socal.rr.com | 1 | 15 |
|  | 94 GMC 350 with a broken fitting that threads into the dome at the rear,,
not coming out at all any hints??
MFITZGERALD
|
04-12-2006 07:42 AM
MFITZGERALD | 0 | 12 |
|  | I recently installed a 6' lift kit on my 98 GMC Z71 and am now wondering if
I should just cut my losses and go to an ORU conversion kit and install...
Blair
|
04-12-2006 02:15 AM
Blair | 2 | 11 |
|  | trying to find out if a 96 tanawanda (multi-port intake) has the same
intake bolt pattern as a 93 tanawanda (tbi intake)
blew 93 motor up but i can...
cooter
|
04-11-2006 01:25 PM
cooter | 0 | 11 |
|  | I just bought a 1990 Jimmy fullsize 4x4 with a 350 fuel injected motor.
Lookng at the oil filter, there is a spacer between the filter and the
block...
big e lewis
|
04-11-2006 11:51 AM
I Hate Spam | 2 | 11 |
|  | I have a '96 Blazer 4x4 with 156K miles. It runs fine - no hesitation, no
loss of power, good acceleration. However, when the tank is less than...
Chuck Jurgens
|
04-10-2006 08:48 AM
js | 7 | 8 |
|  | Fatdaddys wrote:
===========
yeah, well that's a little more info than I needed.
I felt more comfortable with the name calling.
Fatdaddys
|
04-10-2006 12:04 AM
Marsh Monster | 13 | 21 |
|  | find an electrical place to look it over. Can-be a kicked or
fried fuse-box. They have-to check all the grounds/first.
Jay m
|
04-09-2006 10:44 PM
Jay m | 0 | 11 |
|  | Left side is good, but right side flashes like one of the front bulbs
is out. The rear right does flash quickly so I replaced the 2 front
amber bulbs...
cabopeter@yahoo.ca
|
04-09-2006 10:13 PM
Jay m | 2 | 10 |
|  | I'm still getting 9.6 miles to the gallon around the clock. I was stold
that I should be getting between 11-15.
1.Replaced plugs and wires with...
mike
|
04-09-2006 09:09 PM
calhoun | 6 | 8 |
|  | HI guys,
1999 Chevy Silverado Z71 5.3.
got a question, I've noticed that when I'm driving slow (under 10mph) and or
coming to a stop and get under...
Adair Winter
|
04-09-2006 07:35 PM
Dennis Mayer | 4 | 13 |
|  | I am swapping a 400 out and putting a 350 tranny in and i want to find out
if i have to swap transfer cases also i have a 208 np for the 400. I...
Jwalk2475
|
04-08-2006 08:31 PM
Jwalk2475 | 2 | 9 |
|  | Hi, I'm looking at installing a 2" suspension lift to my 90 k1500.
Looking at the block and torsion bar indexing key type kit.
Being that I've never...
Chris M
|
04-08-2006 04:30 PM
SnoMan | 1 | 12 |
|  | Our 1992 4X4 2500 has a leaky seal on the transfer output shaft
(according to the dealer). We're currently in Seattle but are heading
back to Detroit...
Travelin' Man
|
04-08-2006 04:23 PM
SnoMan | 3 | 8 |
|  | If the fuel pump is not putting out enough pressure does the fuel pressure
switch stop the motor from getting fire?
Grumpy13
|
04-07-2006 07:09 PM
Shep | 1 | 11 |
|  | I have a 99 Suburban K1500 4x4. I have noticed lately that when taking a
slight turn to the right, it will occasional jerk to the right. ...
Brian Houghtby
|
04-07-2006 06:54 PM
Kevin | 2 | 17 |
|  | I noticed that my right front shock(OEM, 106k miles) is coated with some
kind of light oil, looks like it might be hydraulic fluid. If the shock...
a12vman
|
04-07-2006 11:23 AM
Advocate | 1 | 10 |
|  | I have been trying to narrow down the cause of the vibration this truck
experiences from 57 mph to 65 and then again at 70 mph. Is it possible...
siveman via CarKB.com
|
04-05-2006 09:37 PM
The Nolalu Barn Owl | 5 | 12 |
|  | I have the 6L with a rattle in the steering column every time I turn or hit
bumps. Someone said that it was the intermediate steering shaft. ...
mike
|
04-05-2006 03:43 PM
Bill | 1 | 6 |
|  | 1995 GMC K2500 350 CID V-8. Question about stabilizer shaft link bolt
assembly. When replacing the bolt with the rubber gromments, How much do
you...
David Hill
|
04-05-2006 11:55 AM
David Hill | 0 | 12 |
|  | i have a 90 blazer with a 400 small block out of a 74 impala , anyone
wouldnt happen to know what the marks are when doing the chain and what
should...
joenashville
|
04-05-2006 10:10 AM
SnoMan | 3 | 7 |
|  | A while back,someone posted a message about the oil from the air
filter was shorting out the mass air meter.
A friend of mine just put the K&N air...
Bill
|
04-05-2006 10:04 AM
SnoMan | 5 | 16 |
|  | I have a 1999 Chevrolet Suburban K2500. Several of the lug nut caps are missing,
and I would like to buy some to replace the lost ones.
Do you know...
Mark Filice
|
04-04-2006 11:55 PM
jeff in Atl | 5 | 8 |
|  | Sorry, i know I am pretty late with my comment. Anyway, Ian, this sounds
that you are pretty familiar with these 2002 breakes at a Suburban. Does
the...
Redder
|
04-04-2006 09:33 PM
Redder | 0 | 12 |
|  | When trying to start this 92 s10 v6 chevy blazer it will turn over 1 time,
but will not start and then when turning the ignition to try again...
hughes1
|
04-04-2006 09:21 PM
Doug aka Skippy | 6 | 11 |
|  | My '98 is coming up on 130k.
Before I sink a couple thou into it for new tires, steering parts, engine
mounts, shocks, and so-forth I'm thinking...
(PeteCresswell)
|
04-04-2006 05:09 PM
(PeteCresswell) | 0 | 9 |