| | Rating Thread /
Thread Starter | Last Post  | Replies | Views |
 |  | The heater blower only runs on high. I bought a new Blower Resistor but I
cant find the old one. Where the heck is it? I heard it was behind the...
Louis Cyktor
|
12-19-2005 09:57 PM
Louis Cyktor  | 2 | 15 |
| | | my truck seemed like it would be a little slow starting up, like a
really low idle for a few seconds. i went out of town for two days
with my truck...
mjack24
|
12-19-2005 08:50 PM
irondog | 1 | 16 |
| | | I recently purchased this truck. After driving it a bit, a day came i
needed the defrost. Nothing comes out. If you turn it up on high, you
can...
ronnie.smith.jr@gmail.com
|
12-19-2005 08:44 PM
Bill | 2 | 8 |
| | | truck wont start on its now untill i put alittle fuel in carb. then it will
run as long as i keep foot on fuel peddal as soon as i let off gas then...
BHogue
|
12-19-2005 08:41 PM
irondog | 1 | 16 |
| | | Ok, I have a 99 GMC Jimmy, I am wanting to replace the headlights and fog
lights so far I have the low beams as 9006 thats good, the ones I...
Adam
|
12-19-2005 02:47 PM
Adam | 0 | 15 |
| | | The truck is still at the dealer. They got it fixed late today they said it
was a bad "park-neutral safety switch". I'll pick it up in the morning....
Louis Cyktor
|
12-19-2005 01:14 PM
Charles Bendig | 6 | 9 |
| | | Have had intermittant, and now apparently terminal, problem with no
connection being made to turn over engine to start. Replaced Starter...
s10noturnover
|
12-19-2005 01:05 PM
Charles Bendig | 2 | 10 |
| | | Well... After chasing vacuum gremlins and verifying fuel pressure was
correct, the only other thing was the float height.
After reading a less than...
Jon Pickens
|
12-19-2005 10:10 AM
Jon Pickens | 5 | 12 |
| | | I have heard you can put 305 heads on a 350 engine. Will this help me
or hurt me ?...I am rebuilding a 3790010 block and the 336 heads on it r
okay...
Chevrolet
|
12-19-2005 05:14 AM
Charles Bendig | 1 | 16 |
| | | wont start until i spray carb cleaner in throutle body.after that runs fine
zayka
|
12-19-2005 05:02 AM
Charles Bendig | 6 | 9 |
| | | 2001 Chevy 1500 Z71 - Just over 90k. Super truck...just bought a Nissan
Titan and need to sell. Has Chrome Daimond Plate Toolbox, Bed caps &...
NJ
|
12-18-2005 09:43 PM
NJ | 0 | 14 |
| | | I have trouble with my S10 Blazer-98 the 4wd dont work. Its not
possible to shift betwen 2hi 4hi and 4lo. I tryed to change the motor
and encoder on...
jerica.tuthill@booomail.com
|
12-18-2005 09:03 PM
Raymond Lopiccolo | 3 | 12 |
| | | Hi... I'm about to start playing around with some analog-to-digital
stuff--mainly logging data through an RS-232 port on a laptop.
I'm curious as to...
Jon Pickens
|
12-18-2005 11:49 AM
Steve Mackie | 5 | 13 |
| | | I have a 1998 K1500 with the selectable (2hi button and 4hi/4lo button)
4wd with the nv243 transfer case and would appreciate some tips on what
to...
old_guy
|
12-18-2005 07:58 AM
old_guy | 0 | 29 |
| | | Send the ACLU a CHRISTMAS CARD with no return address! As they are
working so very hard to get rid of the CHRISTMAS part of this holiday,
we should...
randy1128@webtv.net
|
12-17-2005 08:56 PM
burntkat@gmail.com | 2 | 14 |
| | | Does anyone have a desktop dyno file for 14102191 heads or accurate flow
numbers. Also where can I find info on newer chevy heads. Exe....
David Johnson
|
12-17-2005 08:26 PM
David Johnson | 0 | 19 |
| | | http://www.streetofrace.com/start.php?p=zarob&user=2548
Marc
|
12-17-2005 06:02 PM
Marc | 0 | 19 |
| | | i bought a 97 jug for my 89 2500 4 wheel drive. i have everything installed but do not know how to hook up the wiring for the actuator, etc..... can...
fqrq1970
|
12-17-2005 06:00 PM
fqrq1970 | 0 | 15 |
| | | happened to me too. I also did the same checks as you. I also blew the line
out from front to back and back to front before droping the tank to...
kamaka
|
12-16-2005 09:19 PM
kamaka | 0 | 22 |
| | | Recently the wiper motor on my C1500 went bad. I have bought a new motor but
noticed that the crank arm must be taken off the old motor and placed...
FlyingMike via CarKB.com
|
12-16-2005 07:56 PM
FlyingMike via CarKB.com | 0 | 10 |
| | | no preference to Chevy, Ford or Dodge.
Alex
|
12-16-2005 01:38 PM
Alex | 0 | 14 |
| | | I have been unable as of yet to find a wiring diagram for the tank selector
switch and actuator in my '76 3/4T chassis. Anyone have a link where I...
Shades
|
12-16-2005 09:55 AM
Shades | 4 | 13 |
| | | Does anyone know how to check the fluid level?
The truck has been parked for over a year and I just wanted to make
sure it was full.
Thanks,
Tony
loadedpampers@gmail.com
|
12-16-2005 06:51 AM
daytona | 1 | 12 |
| | | i bought the truck a couple of weeks ago. the tranny was wworking fine
when i got it but after driving it about 60 miles i lost 3&4 gears. i
replaced...
tex8504
|
12-15-2005 10:13 PM
tex8504 | 1 | 12 |
| | | can some one help me i need to check fluid level in the transfer case but
dont know where the fill hole is located
mpd
|
12-15-2005 03:52 PM
Steve Mackie | 3 | 11 |
| | | The better half used the hazards the other night. with no problem,
after turning them off she noticed no turn signals, now the hazards
don’t work...
danieltroll
|
12-15-2005 03:13 PM
ba5416 | 3 | 11 |
| | | Just bought a device on internet that will allow me to connect iPod to
factory stereo CD changer input. I need to get to the back of the
stereo to...
c
|
12-15-2005 10:09 AM
c | 5 | 15 |
| | | when the weather turns cold, my truck takes alot longer to start/turn over.
What's the most probably cause of this? I'm thinking weak batter myself...
Michael McNeil
|
12-15-2005 02:10 AM
Michael McNeil | 2 | 10 |
| | | i have 96 chevy s10 how do i check to see what is draining battery over
nite?
COCO10
|
12-14-2005 04:14 PM
no one | 3 | 12 |
| | | How do I get a GM part number for a Transfer Case Control Module? Its for a
99 Jimmy 4 button switch with NP8 transfer case.
Adam
|
12-14-2005 09:41 AM
Adam | 10 | 40 |
| | | I had the tranny rebuilt a couple months back.., now I notice when I'm
driving around 70-75 mph on the hyw between California and Arizona when I...
81mm
|
12-14-2005 09:32 AM
81mm | 2 | 10 |
| | | Hi all,
I have a 2000 silverado LS Z71 with 5.3l and 66k on the clock. The
truck hasn't been driven much in the last year and until recently...
genius@socal.rr.com
|
12-14-2005 09:16 AM
genius@socal.rr.com | 4 | 9 |
| | | I WAS TRAVELING HOME FROM THE WEIGHTROOM, TRUCK SLIPPED OUT OF GEAR IN
NEUTRAL. I HAVE NO IDEA WHAT HAPPEN ANYBODY HAVE ANY IDEAS OF WHAT IT MAY...
rams0777
|
12-13-2005 11:57 PM
rams0777 | 0 | 12 |
| | | I WAS TRAVELING HOME FROM THE WEIGHTROOM, TRUCK SLIPPED OUT OF GEAR IN
NEUTRAL. I HAVE NO IDEA WHAT HAPPEN ANYBODY HAVE ANY IDEAS OF WHAT IT MAY...
rams0777
|
12-13-2005 11:56 PM
rams0777 | 0 | 13 |
| | | Anyone know how to disable the anoying auto door lock feature on a 1999 Chevy
Silverado1500 pick-up?
zimster
|
12-13-2005 05:03 PM
honk_on_bobo | 2 | 15 |
| | | I just consulted the LMC catalog. It appears the soft-top only option
was available from 73-81. They have the gate, but the latching system
appears...
Jon Pickens
|
12-13-2005 04:34 PM
Jon Pickens | 6 | 11 |
| | | Iam having problems with getting it started checked my battery and its
good my next options would be starter and altenator but cant find...
juanb
|
12-13-2005 02:43 PM
Shoe Salesman | 4 | 9 |
| | | i can't figure out how to get the heater box out or get the core out with
the box still in the truck. please help quick.
medic83227
|
12-13-2005 12:39 PM
medic83227 | 0 | 25 |
| | | any Ideas as to what would cause This vehicle to fire up first try from a
cold start. but hesitates if the engine is warm.
robink
|
12-13-2005 11:52 AM
robink | 0 | 11 |
| | | Recently my 95 C1500 with ABS brakes has started having brake problems. If I
hold firm pressure on the brake pedal, it will slowly but eventually...
FlyingMike
|
12-13-2005 09:49 AM
Doug | 4 | 16 |
| | | Have 99 S-10 2wd. Have trouble getting it started turns over but wont
start have to turn key severeal times in order to get it started. Once
on runs...
nano31
|
12-13-2005 05:26 AM
Adam | 1 | 16 |
| | | I bumped a deer the other night busted my headlight and cracked the grill
nothing major drove it home the next day it won't start checkrd the...
alyssa121
|
12-13-2005 01:06 AM
alyssa121 | 0 | 11 |
| | | I have a 85 K5 Blazer ,Runs great until I get on the highway, No top end
power slows down going up hills,(tractor trailers pass me) Hard starting...
sparkie
|
12-12-2005 06:11 PM
Blair | 9 | 14 |
| | | PARTING OUT!!! EVERYTHING MUST GO!!!
1988 K10 Suburban - Body rough, no engine/trans/transfer case, no
buckets/center console. 3.73 axles in GOOD...
Shades
|
12-12-2005 06:10 PM
Blair | 2 | 15 |
| | | I have decided to upgrade the brakes on my GMC Sierra K1500 Z71 to a larger
disc and rotor. I am doing this because I am upgrading to a set of 36...
Blair
|
12-12-2005 06:06 PM
Blair | 0 | 15 |
| | | Was cleaning the battery terminals the other day and got locked out of the
radio. The book says turn key on and push 1 and 4 together to...
Paul
|
12-12-2005 04:08 PM
Paul | 0 | 11 |
| | | can anyone describe headlight adj. 04 chev silverado?
lowered
|
12-11-2005 08:34 PM
lowered | 2 | 5 |
| | | i have a 88 cheve 1/2 ton pick up with a problem. i took it to autozone,
and they did some kind of diagnos test on it and it came up code 34.witch
is...
bounce
|
12-11-2005 07:19 PM
Steve Mackie | 4 | 16 |
| | | i have a 99 dodge ram with a v10 motor. my question is. i disconected
two plugs on the drivers side under the hood right by the brake fluid
resivor....
Ron Miller
|
12-11-2005 01:40 PM
Steve Mackie | 1 | 11 |
| | | I have an '88 chevy 2500 4x4 standard cab, and a Meyer angle plow setup
for an '87 and older chevy. The plow is the standard/conventional non
EZ...
Tom H
|
12-11-2005 09:17 AM
Shades | 5 | 11 |
