AutosTalk Forums  

Need to prevent doors from freezing up

4x4 Chevy/GMC Trucks 4x4 Chevy/GMC Trucks Discussions (alt.autos.4x4.chevy-trucks)


Discuss Need to prevent doors from freezing up in the 4x4 Chevy/GMC Trucks forum.



Reply
 
Thread Tools Display Modes
  #1  
Old   
Robert
 
Posts: n/a

Default Need to prevent doors from freezing up - 12-15-2008 , 03:12 AM






I have a 91 Sierra truck. Earlier today it rained, then got cold and
later I could not get into the truck. I finally managed to open one
door on pass side. The driver door is still stuck. I was not within
close reach to an outlet to use a hair dryer. At least now I moved
the truck near an outlet. If I had not been able to pound with my
fist and force the door I would have been locked out. Using a torch
on the paint did not seem like a good idea. But without electricity
there would have not been another way.

My thought is that what is needed is a preventative measure. Applying
something around the door seal. But what? I'd rather not use
something that will get all over my clothing, like auto grease. I
suppose vaseline would not be too bad of a mess, but maybe there's
something else. Does anyone have any ideas? My other thought is
silicone spray, but that seems to evaporate in a short time.

What can I use?

I should mention that I have had this problem on other vehicles, but
because of the door design, this truck seems to get worse.

Thanks for all advice

Bob


Reply With Quote
  #2  
Old   
Steve W.
 
Posts: n/a

Default Re: Need to prevent doors from freezing up - 12-15-2008 , 11:44 AM






Robert wrote:
Quote:
I have a 91 Sierra truck. Earlier today it rained, then got cold and
later I could not get into the truck. I finally managed to open one
door on pass side. The driver door is still stuck. I was not within
close reach to an outlet to use a hair dryer. At least now I moved
the truck near an outlet. If I had not been able to pound with my
fist and force the door I would have been locked out. Using a torch
on the paint did not seem like a good idea. But without electricity
there would have not been another way.

My thought is that what is needed is a preventative measure. Applying
something around the door seal. But what? I'd rather not use
something that will get all over my clothing, like auto grease. I
suppose vaseline would not be too bad of a mess, but maybe there's
something else. Does anyone have any ideas? My other thought is
silicone spray, but that seems to evaporate in a short time.

What can I use?

I should mention that I have had this problem on other vehicles, but
because of the door design, this truck seems to get worse.

Thanks for all advice

Bob

Best stuff I have used is Silicone boot waterproofer. The type that is
in a bottle with the cotton ball applicator. Couple coats and no more
stuck doors.

--
Steve W.
Near Cooperstown, New York


Reply With Quote
  #3  
Old   
Carroll Robbins
 
Posts: n/a

Default Re: Need to prevent doors from freezing up - 12-16-2008 , 12:46 PM



Robert <rofillmore (AT) nogospammail (DOT) com> wrote on Mon, 15 Dec 2008 02:12:02
-0600 in <ea4ck4l4ekjo68llpm30dm4jr1ao4rqdeo (AT) 4ax (DOT) com>

Quote:
If I had not been able to pound with my
fist and force the door I would have been locked out. Using a torch
on the paint did not seem like a good idea. But without electricity
there would have not been another way.
Hot water.
--
Carroll Robbins


Reply With Quote
  #4  
Old   
Ken
 
Posts: n/a

Default Re: Need to prevent doors from freezing up - 12-16-2008 , 04:18 PM



On Dec 16, 9:46*am, Carroll Robbins <carrollrobb... (AT) ioa (DOT) com.invalid>
wrote:
Quote:
Robert <rofillm... (AT) nogospammail (DOT) com> wrote on Mon, 15 Dec 2008 02:12:02
-0600 in <ea4ck4l4ekjo68llpm30dm4jr1ao4rq... (AT) 4ax (DOT) com

If I had not been able to pound with my
fist and force the door I would have been locked out. *Using a torch
on the paint did not seem like a good idea. *But without electricity
there would have not been another way.

Hot water.
--
Carroll Robbins
Maybe warm water.
Knew a guy (not the brightest bulb on the tree) who poured hot water
on his frozen-up windshield..
Ya kin guess what happened


Reply With Quote
  #5  
Old   
Robert
 
Posts: n/a

Default Re: Need to prevent doors from freezing up - 12-17-2008 , 03:15 AM



On Mon, 15 Dec 2008 11:44:29 -0500, "Steve W." <csr684NOT (AT) yahoo (DOT) com>
wrote:

Quote:
Robert wrote:
I have a 91 Sierra truck. Earlier today it rained, then got cold and
later I could not get into the truck. I finally managed to open one
door on pass side. The driver door is still stuck. I was not within
close reach to an outlet to use a hair dryer. At least now I moved
the truck near an outlet. If I had not been able to pound with my
fist and force the door I would have been locked out. Using a torch
on the paint did not seem like a good idea. But without electricity
there would have not been another way.

My thought is that what is needed is a preventative measure. Applying
something around the door seal. But what? I'd rather not use
something that will get all over my clothing, like auto grease. I
suppose vaseline would not be too bad of a mess, but maybe there's
something else. Does anyone have any ideas? My other thought is
silicone spray, but that seems to evaporate in a short time.

What can I use?

I should mention that I have had this problem on other vehicles, but
because of the door design, this truck seems to get worse.

Thanks for all advice

Bob


Best stuff I have used is Silicone boot waterproofer. The type that is
in a bottle with the cotton ball applicator. Couple coats and no more
stuck doors.
This sounds like a good plan.
Thanks



Reply With Quote
  #6  
Old   
Robert
 
Posts: n/a

Default Re: Need to prevent doors from freezing up - 12-17-2008 , 03:15 AM



On Tue, 16 Dec 2008 13:18:30 -0800 (PST), Ken <flakey714 (AT) aol (DOT) com>
wrote:

Quote:
On Dec 16, 9:46*am, Carroll Robbins <carrollrobb... (AT) ioa (DOT) com.invalid
wrote:
Robert <rofillm... (AT) nogospammail (DOT) com> wrote on Mon, 15 Dec 2008 02:12:02
-0600 in <ea4ck4l4ekjo68llpm30dm4jr1ao4rq... (AT) 4ax (DOT) com

If I had not been able to pound with my
fist and force the door I would have been locked out. *Using a torch
on the paint did not seem like a good idea. *But without electricity
there would have not been another way.

Hot water.
--
Carroll Robbins

Maybe warm water.
Knew a guy (not the brightest bulb on the tree) who poured hot water
on his frozen-up windshield..
Ya kin guess what happened
Let me guess..........
Ummmmmmmmmmmm
Huh Hummm AHHHHH.....
Hum Hmmmmmmmmmm
UhHa.....

I think I get it....
His wife boiled the water,
so when he poured it on the frozen windshield
His wife's water broke !!!!!!!! ^ ,,,): ! -|--<




Reply With Quote
  #7  
Old   
NotMe
 
Posts: n/a

Default Re: Need to prevent doors from freezing up - 12-17-2008 , 08:44 PM




"Carroll Robbins" <carrollrobbins (AT) ioa (DOT) com.invalid> wrote

: Robert <rofillmore (AT) nogospammail (DOT) com> wrote on Mon, 15 Dec 2008 02:12:02
: -0600 in <ea4ck4l4ekjo68llpm30dm4jr1ao4rqdeo (AT) 4ax (DOT) com>
:
: >If I had not been able to pound with my
: >fist and force the door I would have been locked out. Using a torch
: >on the paint did not seem like a good idea. But without electricity
: >there would have not been another way.
:
: Hot water.

Cracked/shattered glass



Reply With Quote
Reply




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Powered by vBulletin
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.