After a recent timing belt change, I'm getting a strange swishing
sound from the engine when the engine is cold - about once a second at
idle, increasing with engine speed. It disappears when the engine
warms up a bit. It's not the serpentine belt, as the noise is still
there when the belt's off. Nor is it the belt rubbing against the
timing belt covers, as I've tried taking those off too. Any
suggestions?

"Hooch" <HoochXX (AT) googlemail (DOT) com> wrote

over tight in general? then any extra tight bits will make a noise

The message <kGe3i.25523$Ug.17059 (AT) fe1 (DOT) news.blueyonder.co.uk>
from "MrCheerful" <nbkm57 (AT) hotmail (DOT) com> contains these words:

Sounds like it - though some makes of belts are just noisy anyway. Try
dribbling a little water onto the back of the cambelt as it goes round
and see if it shuts up. In the past I've found a tiny squirt of WD40 or
silicone spray will shut up a belt with no adverse effects.

--
Skipweasel
We have always been at war with Iran. [George Orwell - almost]

"Hooch" <HoochXX (AT) googlemail (DOT) com> wrote

does the new belt have a sticky patch on the back, where a manufacturers
sticker had been. could be when its warm the sticky reduces.

On May 18, 10:51 am, "MrCheerful" <nbk... (AT) hotmail (DOT) com> wrote:
Don't think so. When installed it could be turned through 90 degrees
with two fingers, but I'll take the covers off and check again.

On May 18, 12:19 pm, Guy King <guy.k... (AT) zetnet (DOT) co.uk> wrote:
I'll certainly try that and report back with results!

The message <1179496722.721180.306980 (AT) h2g2000hsg (DOT) googlegroups.com>
from Hooch <HoochXX (AT) googlemail (DOT) com> contains these words:

Ah - I've done that and had belts that turned out to be very much too
tight. Perhaps I just have very strong fingers.

--
Skipweasel
We have always been at war with Iran. [George Orwell - almost]