The flasher relay behind my hazard warning switch carries on working after
I have used my turn signals, it does not flash the signal lights but just
makes a clicking noise, sometimes once or twice sometimes for a couple or
minutes.
I had the hazard switch replaced 18 months ago because it was causing the
turn signals to malfunction, could this switch be causing the problem
again.
I noticed in the hand book the turn signal relay is in the fuse box, but
the clicking sound comes from the hazad switch and you can feel it through
the switch too.
Any advice?

Chris

Top Post!!!!!!!
Sounds like you need a new switch...Common problem...
Steve C
2000 Malibu Turn signal and hazard flashers

Group: alt.autos.chevrolet.malibu Date: Wed, Aug 11, 2004, 12:32pm
(CDT+1) From: bloke (AT) rogers (DOT) com (bloke)
The flasher relay behind my hazard warning switch carries on working
after I have used my turn signals, it does not flash the signal lights
but just makes a clicking noise, sometimes once or twice sometimes for a
couple or minutes.
I had the hazard switch replaced 18 months ago because it was causing
the turn signals to malfunction, could this switch be causing the
problem again.
I noticed in the hand book the turn signal relay is in the fuse box, but
the clicking sound comes from the hazad switch and you can feel it
through the switch too.
Any advice?
Chris

Thanks for verifying the problem for me.
Next question, how the hell do i get to the switch?It seems like you have
to take all the trim off from around the dials too, is there an easier
way?
Any help will be appriciated.

Chris

Thanks for verifying the problem for me.
Next question, how the hell do i get to the switch?It seems like you have
to take all the trim off from around the dials too, is there an easier
way?
Any help will be appriciated.

Chris

Re: 2000 Malibu Turn signal and hazard flashers

Group: alt.autos.chevrolet.malibu Date: Thu, Aug 12, 2004, 9:11am
(CDT+1) From: bloke (AT) nospam (DOT) rogers.com (bloke)
Thanks for verifying the problem for me. Next question, how the hell do
i get to the switch?It seems like you have to take all the trim off from
around the dials too, is there an easier way?
Any help will be appriciated.
Chris



You have to take off the whole molding...All the way acrossed the dash
...
Steve C

I kind of figuered as much, I can only see the 2 screws around the clocks,
is there any other's hidden or otherwise? or is there just clips that you
pop out.
I dont want to start pulling off bits of moulding that are not meant to be
pulled off!

No should be just the 2 screws in from of the IP Cluster the rest are
just clips
Steve C
Re: 2000 Malibu Turn signal and hazard flashers

Group: alt.autos.chevrolet.malibu Date: Sun, Aug 15, 2004, 5:11pm
(CDT+1) From: bloke (AT) nospam (DOT) rogers.com (bloke)
I kind of figuered as much, I can only see the 2 screws around the
clocks, is there any other's hidden or otherwise? or is there just clips
that you pop out.
I dont want to start pulling off bits of moulding that are not meant to
be pulled off!