2001 'bu cruise control

#11

I had made a joke about this earlier, but it seems that other people have
the same problem. Get a piece of wood that you can wedge between the seat
and the brake pedal. 2X4, 1X2, cut down broom handle, typical snow brush
works to. If it's a bit too short or long, move the seat up/back.

When I worked in the garage (years ago) I had a 1X4 with a hole drilled in
it to snuggly fit a shortened broom handle. Put the one end of the broom
handle against the brake pedal and slide/wedge the board up against the
seat. Worked in every vehicle.

"Rod & Betty Jo" <soggy45 (AT) hotmail (DOT) com> wrote

Quote:

Russg wrote:
I checked out my high mount brake bulbs and wiring. They seem fine,
the hard part was getting to the rear after pushing the brake pedal
before the light went out. One bulb is a little dim.

Bummer...bulbs being the easiest cruise repair ever.....Mine worked fine
with either or both bulbs......When alone if I need to check bulbs/lights
I either back up near a garage door or lean a piece of plywood on a
garbage can directly behind the light in question..for the center light
I'd probably lean a board over the center(outside) of the rear
window...Good luck Rod

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

2001 'bu cruise control

Chevrolet Malibu Chevrolet Malibu Discussions (alt.autos.chevrolet.malibu)

Re: 2001 'bu cruise control - 07-09-2007 , 06:19 PM