AutosTalk Forums  

Sponsored Links


Ford Trucks Ford Trucks (alt.trucks.ford)


Discuss in the Ford Trucks forum.



Post New Thread
Threads in Forum : Ford Trucks Forum Tools Search this Forum
  Rating Thread / Thread Starter Last Post Reverse Sort Order    Replies         Views     
I purchased my F150 new in late '01 and it has the compass and ambient temperature reading in the console between the visors. The...
Drigo
12-17-2006 01:43 PM
Marlin Singer Go to last post
4 20
My 1997 F150 is overheating. This summer I changed my coolant (I hadn't done it in quite a while) The coolant appeared to be quite rusty and it took...
TP
12-17-2006 08:06 AM
SnoMan Go to last post
2 25
Just bought this truck and starter went out, but I can't find the starter on it - can someone please tell me where it is located? It is a 1990 V6 4.0...
bunkle@cfl.rr.com
12-16-2006 06:14 PM
Jeff Strickland Go to last post
2 13
My two cents worth. You are making a judgement on the low end tires you bought after less than 6 months on the truck. As far as I am concerned, SL or...
Whitelightning
12-16-2006 02:48 PM
Rowbotth Go to last post
4 18
My '81 300/6 has this and I'm wondering what I can install to get a hotter spark? Except for the cap/rotor/plug wires the ignition system is 25+yrs...
putt@webtv.net
12-16-2006 11:26 AM
ds549@webtv.net Go to last post
5 17
"Jack" <dg303 (AT) sbcglobal (DOT) net> wrote same reason you would use prodigy.net.....TROLL
NoSpam
12-15-2006 07:55 PM
phaeton Go to last post
20 30
Oil companies are pulling in record profits and the government says they can't do anything about it. Hurricanes have knocked the oil refineries down...
rbkrqkqfbehc@yahoo.com
12-15-2006 11:10 AM
Mac Cool Go to last post
2 14
My 95 F150 has over 200000 miles on it and the bearings are shot in the steering column and the overdrive switch does not work. The switch itself is...
hgp46@yahoo.com
12-14-2006 02:28 PM
Jeff Strickland Go to last post
2 18
Hi- Got my truck 92 f150 302 running and now is posting a 334 code. (EGR closed voltage higher than expected) I replaced the EGR sensor last spring...
Dave
12-14-2006 12:37 AM
Stephen H Go to last post
1 10
my son has a 86 bronco that will not start. he has spark at the plugs but the fuel pumps will not pump any fuel, replaced both pumps, filters and...
Brad
12-13-2006 06:53 PM
JimV Go to last post
2 13
Sometimes after you start the engine the rear anti-lock light stays on, dim... When this happens the blinkers don't work, blower motor does't work...
latv@webtv.net
12-13-2006 06:51 PM
JimV Go to last post
5 10
I have changed the ignition module, distributer cap, rotor, plugs, wires, starter and still will not start. It will turn over, but will not start. I...
dfollis@nts-online.net
12-12-2006 05:38 PM
dfollis@nts-online.net Go to last post
3 7
I have a 94 F-150 that is experiencing some strange problems. Half of my electrical components are working and half are not. What is even stranger...
tgrahl@earthlink.net
12-12-2006 05:34 PM
Steve Barker LT Go to last post
6 10
97-350 7.3 diesel Super duty Heater blows cold air, changed the heater core, no change. Engine runs at operating temp fine, fluid level is good. must...
Expediter
12-12-2006 12:08 PM
Nemisis Go to last post
2 6
This is my 8th Ranger over the years, I love them.... BUT Ford has the speed limiter set on it to 92 mph on this 2001 Edge extended cab....ridiculous...
12-12-2006 10:32 AM
C. E. White Go to last post
13 41
On Tue, 10 Oct 2006 21:06:58 -0700, I. Care <icare (AT) spamthis (DOT) com> wrote: Yeah, I had (have) a GMC van that had about three ongoing...
Bob
12-11-2006 08:10 PM
Jack Go to last post
6 12
My powerpoint outlet quit working shortly after I purchased my F-250 in 2001. I've been using my cigarette lighter instead. Lately I've wondered...
cschahn@gmail.com
12-11-2006 07:34 PM
My Name Is Nobody Go to last post
1 15
Hello all, The shocks are done. The top right and both bottom rear bolts were a little rusted; they broke loose under reasonable effort, but...
Bill Schwab
12-11-2006 05:59 PM
Whitelightning Go to last post
1 13
Hi Does anyone know the best approach to replacing dash lights on a '97 Ranger? I'm not sure whether to start digging from the top side or underside...
fazelock@yahoo.com
12-10-2006 11:16 PM
CJB Go to last post
2 19
96 F150, 5L, 5 speed manual, 2wheel drive. 2 piece driveshaft. Rear shaft rear yoke unbolts from pinion ok, front yoke connects to slip-joint (no...
mjs
12-10-2006 10:54 PM
Whitelightning Go to last post
4 9
I'm having problems with my battery draining after about 5 hours when sitting. After checking the battery and alternator I narrowed it down by...
Vince
12-10-2006 10:17 PM
Steve Barker LT Go to last post
6 16
I have never had a diesel with dual tanks before so am not sure how to approach it. With gas engine I have simply run one tank out and then switched...
M Warren
12-10-2006 09:54 PM
Steve Barker LT Go to last post
10 20
Hi All- I'm replacing my ECM. I've got the wireing harness and nuts off the firewall side. Does it pull out throught the firewall or does one have...
Dave
12-10-2006 09:49 PM
Steve Barker LT Go to last post
1 12
Need procedure to R & R the steering wheel.
jay
12-09-2006 11:16 PM
jay Go to last post
0 11
Suddenly, the gas gauge went crazy. Have dual tanks, front tank shows empty and rear tank shows pegged on full side. What would cause both to go...
Burgy
12-09-2006 10:35 PM
Steve Barker Go to last post
4 11
OK all I ran out of fuel in my Ranger and after putting fuel back it wouldn't start. What do I need to do in order to get if started. Renald353407...
Renaldo353407@yahoo.com
12-09-2006 10:33 PM
Steve Barker Go to last post
4 16
No grinding just hard to get into gear with clutch all the way down. While at a stop, effort is less if you go from 2nd to 1st gear then let out the...
ndccpf1@gmail.com
12-09-2006 07:12 PM
tomcas Go to last post
6 15
Hey all. I'm having some problems removing the rear panels in a 2002 Ranger Super Cap. It looks like the whole panel just pops out. But after a...
michaelpladd@gmail.com
12-08-2006 08:23 AM
Blue Oval/Dan Edwards Go to last post
1 14
I have a 2002 F150 with a 4.2 and the service engine light is on. The code is a vacuum leak, or so I was told. The place that used the scanner...
MrBlues
12-07-2006 03:27 PM
Jeff Strickland Go to last post
1 12
Hello all, Does anybody have any opinions about the 6-0 powerstroke going into a 4x4 150, or any other diesel conversion that you may know about. I...
john.van.v@gmail.com
12-06-2006 02:08 PM
Eb Go to last post
2 28
Thank, much appreciated. Bill "David M" <NOSPAM (AT) nospam (DOT) com> wrote
Bill Wittmer
12-05-2006 09:28 PM
Jerry Go to last post
2 22
2005 4x4 Screw with 55K on it that has an intermittent steering wheel vibration from 65-75mph. Tires have been balanced, road force balance, etc....
ephedralover@hotmail.com
12-05-2006 03:06 PM
Marlin Singer Go to last post
2 13
Have this nice old truck and the idle is really inconsistent. It will bog, then over-rev trying to recover then hold idle for a few. And...
Carl Beyer
12-05-2006 08:30 AM
Nemisis Go to last post
1 17
The fuel pump on my 92 Ranger 3.0L does not stop running after a few seconds when the key is turned on. The engine will not fire. I'm getting fuel...
ScottG
12-04-2006 03:23 PM
ScottG Go to last post
0 17
I've been having trouble with my 2002 F350 7.3 for over three months now. The only info I've gotten is "water in the fuel" or "bad injectors". I took...
Safety man
12-04-2006 09:53 AM
Chris Hill Go to last post
5 15
I'm trying to find out what model Ford in-dash changers are compatible with a 2000 F150. The truck currently has a single disc in dash unit that is...
kats8P
12-04-2006 06:51 AM
Joe S. Go to last post
2 14
"David M" <NOSPAM (AT) nospam (DOT) com> wrote That and RPM on startup is supposed to be higher than idle to get the oil distributed throughout the...
tom graham
12-03-2006 07:25 AM
Matt Macchiarolo Go to last post
2 13
Hey all. I'm having some problems removing the rear panels in a 2002 Ranger Super Cap. It looks like the whole panel just pops out. But after a...
michaelpladd@gmail.com
12-02-2006 01:13 PM
michaelpladd@gmail.com Go to last post
0 14
Hello, I may have a chance to buy a 1999 Ford E350 Chateau van. It is pretty much loaded and only has ~ 30K or less. It's a V8 with most of the...
Peter Bogiatzidis
12-02-2006 05:55 AM
websurfer Go to last post
1 16
Hello all, Re my "new" 1996 F150 (straight 6, 75k miles) was squeaking on a short trip this evening. We have had a couple of moderately rainy days...
Bill Schwab
12-02-2006 12:04 AM
Bill Schwab Go to last post
0 11
My 07 Powerstroke F350, has 3 gauges; oil pressure, transmission temperature, engine temperature. Has anyone a link they could post to a website...
J & S
12-01-2006 03:41 PM
J & S Go to last post
6 16
Got a 1993 Ford XLT F150. The mounting bracket that is riveted to the frame and holds the back end of one of the rear leaf springs has rusted and...
Burgy
12-01-2006 01:03 AM
Paul Brown Go to last post
6 19
I have a 1996 F-150 2wd 5.0 automatic. I had the transmission rebuilt about 3 months ago, for the next two weeks it was taking upwards of two or...
TXFIGHTINGAGGIE2010
11-30-2006 10:48 PM
TXFIGHTINGAGGIE2010 Go to last post
0 10
Does anyone else out there drive a diesel Ranger? I've comleted the engine swap from an '83 into my '84 and so far things are working well. Does...
vernon.woolsey@gmail.com
11-30-2006 09:53 PM
vernon.woolsey@gmail.com Go to last post
2 20
David M: very good, thanks. -- Mac Cool
Mac Cool
11-30-2006 11:26 AM
vernon.woolsey@gmail.com Go to last post
6 18
I found the RAB connector and grounded it and it gave me one fast flash and one long code that = code #2. In the manual it says to unconnect the 2...
:\
11-30-2006 01:57 AM
:\ Go to last post
2 12
Has anybody done this seal replacement? I mean, assuming the bushing is not bad, how hard is this job? Specifically, would I need a seal puller or...
oily_boot2
11-29-2006 11:04 PM
oily_boot2 Go to last post
0 10
The vehicle: a 1999 F-250 XLT I'm looking to find out how to replace the door windows in the truck. A very dark tint was applied years ago and it...
murph101@webtv.net
11-29-2006 07:51 PM
Rodan Go to last post
1 10
My son just got a 2002 Explorer. He took it to the Ford dealer to have the transmission fluid and filter changed. They told him the filter...
Nemisis
11-29-2006 09:11 AM
SnoMan Go to last post
1 9
Hi everyone, have on 06 f150 XL with the 7 lug wheels. Just wondering if anyone has had any luck finding aftermarket wheels for the new heavy duty 7...
Chris M
11-28-2006 01:03 PM
Mike H Go to last post
10 34
Post New Thread

Display Options
Showing threads 401 to 450 of 5096
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.