On Tue, 22 Jul 2003 01:04:33 -0000, "designo" <designo (AT) comcast (DOT) net> wrote: package in the glove box that had a relay which needed to be...

Chris Hill

07-25-2003 12:34 AM
Tom J

is there anyway to bring the gas pedal up to be more even with brake pedal, or lower brake pedal, its a pain to drive with my feet and bad knees,...

Ray High

07-25-2003 12:26 AM
Ray High

On 24 Jul 2003 16:12:04 -0700, steventhomas42 (AT) yahoo (DOT) com (Steve Thomas) wrote: No idea, but if it is just hanging there have you tried...

Col. RSJ

07-24-2003 11:03 PM
Joe

I am looking at a 93 truck with a 7.3 diesel in it. When it is first started, it seems to run rough for maybe 20 seconds, then it smooths out. Is...

mainiacs

07-24-2003 09:42 PM
Steve Barker

ok with your engine cold , undo the wire connector to the coil , remove the small bolt holding the coil down ( either 8 mm or 10 mm socket) then...

jerry

07-24-2003 08:51 AM
Chevy

Is there any know problem with this engine ( 4.6 ) liter for cylinder # 8 burning a hole in the piston ? the form Mechanic said that the wrong spark...

Chevy

07-24-2003 02:49 AM
Chevy

short also the truck is black matching grill and bumpers the only chrome on it is the tube step bars

Tim Butler

07-23-2003 06:43 PM
Tim Butler

Most Chrome shop's redo wheels or bumper repair shop's "Frank" <duzenski (AT) snet (DOT) net> wrote

D

07-23-2003 10:30 AM
D

Please explain "to phase" thanks !! "Michael Shealy" <DontEmailToMe (AT) yahoo (DOT) com> wrote

Michael Shealy

07-23-2003 12:49 AM
Justbrilliant

I just replaced all ball joints, tie rods and wheel bearings on my 1992 Ranger 2wd. When I had it apart I noticed that the brake caliper pistons...

Dale Randall

07-22-2003 11:10 PM
Scott

<'Z' @georgian.net> wrote It's not unusual for paint to flake on any type vehicle anymore. Just look as you drive along. It all started in the...

Tom J

07-22-2003 11:08 PM
Joe

Anyone using an aftermarket turbo air intake/breather for the 7.3 ltr powerstroke? I drove one with this equipment and noticed a big difference in...

rmb

07-22-2003 02:50 PM
rmb

I'll go along with the others on this one. Blown head gasket. If it smoked continuously I'd say look at the rings. Another check which might be...

Carl Saiyed

07-22-2003 11:59 AM
Gromit

For no other reason then to just push my tires out a little past the fenders I am toying with the idea of using 1/4" wheel spacers. Does anyone have...

badfrog

07-22-2003 04:05 AM
BaghdadBob

I'm looking to buy another used, older E-150 van, but WITHOUT EFI. What was the last model year they offered a carbureted engine? Thanks.

Thomas Graham

07-21-2003 06:21 PM
Frank Damp

Hello alt.trucks.ford, i apologize for the spam If anyone's looking to purchase a set of real train horns for their truck to scare the crap out of...

mh

07-21-2003 12:40 PM
mh

I've got a 2000 F250SD Powerstroke with stick shift. (Love it!) When my wife drives it (seldom) she often puts it in reverse instead of 1st. Not a...

E. Eugene Herbert

07-21-2003 12:18 PM
E. Eugene Herbert

I hit the U-Pull-It salvage lot yesterday and picked up a power steering pump from a '97 (IIRC) F-150 with a 300. Is there any reason why I couldn't...

Keith

07-21-2003 08:58 AM
Keith

"Sean Conolly" <sjconolly_98 (AT) yaaho (DOT) com> wrote : I went through this back in '95, and the info that I got (in person and : later through...

Jack M. King

07-20-2003 07:33 PM
fredzo

jor <jor (AT) jor (DOT) com> wrote Figured out the pedal problem. I wasnt sure where to turn so I figured I'd bleed them the old fashioned way. ...

Cudighi

07-20-2003 06:42 PM
Cudighi

I had a used transfer case installed on my AWD 93 Aerostar 4.0 minivan and noticed that I am getting a loud clanking/clunking sound as soon as I...

JoeBlow@JoeBlow.org

07-20-2003 04:12 PM
Sean Conolly

Have you considered why you need them? Karl -- For information go to: http://www.dalek.org

Karl Shoemaker

07-20-2003 01:52 PM
Karl Shoemaker

no -- Steve (here to have fun) Barker Stilwell, Kansas UP (MoPac) Coffeyville Sub MP 308 Coolpix 995 / PSP 7.04 PS 7 in the background waiting to be...

Steve Barker

07-20-2003 11:57 AM
tater schuld

Got the torx bits for the screws & some carb cleaner and cleaned those MAF babies up today. A new air filter helps some too I'm sure. No...

J.J. Brinks

07-20-2003 06:57 AM
J.J. Brinks

Does anyone know if the Ford Explorer, Expedition, and Excursion have shared platforms with Ford 150, 250, and 350 trucks? Thanks...

EJGroth

07-20-2003 02:19 AM
EJGroth

Gotta love Outlook! It mixed up my posts. Here is the message I intended to send: My Chilton's manual was NO help on this problem. :-( Yesterday I...

Carl Saiyed

07-20-2003 01:25 AM
Joe G

Hi, I am looking for a ford/new holland parts catalog for the 6600/7600 family. Does anybody know where I can download/purchase this ? Thanks in...

JuanC

07-19-2003 06:30 PM
JuanC

gary (AT) gvtc (DOT) com wrote: You might pick up 2-3 hp with the K&N. It will NOT void the warranty. Erik D. '94 white lightning

Erik D.

07-19-2003 05:51 PM
pete

You are correct. The first Super Duty DRW 4x4 had 4 inch blocks, but they don't anymore. I think they only ran it for a year or two with 4" blocks....

Mellowed

07-19-2003 04:51 PM
Ford Prefect

I mistakenly put about 6 gals of gasoline into my 2002 F250. After I discovered the error, I stopped the pump and called a friend who said to fill...

John Bowen

07-19-2003 04:44 PM
Ford Prefect

What is the real average gas consumption of a 6.8L EFI V10 engine, in a 2003 F350 4X4 Super cab pickup truck ?

C.J. Willys

07-19-2003 04:40 PM
Ford Prefect

get the parts they will work on your 72 have a 70 with 490 in it used parts from a 78 to install it--- "KamPerSpesh" <2muchspring (AT) indaback (DOT)...

Dennis

07-19-2003 11:50 AM
Dennis

I got the '69 cab which was destined for the '67 into the shop and started stripping the interior, and found a lot more rust than I previously...

Keith

07-19-2003 11:01 AM
KamPerSpesh

Hi. I hope some one out there can help me with a problem. I have a 1994 Ranger 4.0L 5sp. I need to charge the A/C. The guy at the parts...

UncleDuke

07-19-2003 07:54 AM
UncleDuke

Oh, guess where the passive restraint module is on my '94 Saturn. Right under the cup holder on the console. Condensate from the cups runs...

Cruiser

07-18-2003 11:43 PM
David Ward

My wife has a 2000 Escape and while driving (especially in wet weather), she looses ALL power. The dash board warning lights come on and everything...

Kevin Crozier

07-18-2003 08:25 PM
jor

Was washing my truck today and found what appears to be some surface rust on my bumper. Anybody know what the warranty says about that? Will Ford...

GAC25

07-18-2003 03:57 PM
GAC25

My father picked up a recharge kit at Benny's and uses it to recharge his '95 Dodge Intrepid's a/c. Works fine. I don't know what would happen...

BD

07-18-2003 03:57 PM
Richard Cox

I was hoping for better, but expected less! Heres my slips: run # 1 60' 2.267 330' 6.356 1/8 9.721 MPH 73.09 1000' 12.632 1/4 15.098 MPH 91.32

Erik D.

07-18-2003 11:46 AM
Forcefan83

It seems like you could just get some more sensors installed in your new wheels. I think it would be worth the extra cost. Randy "NJ Vike"...

dad2468

07-18-2003 06:05 AM
NJ Vike

How new? Some newer ones have sixteen inch wheels so even if the bolt pattern is right, you'll need new tires. "Jack M. King" <rebelson (AT)...

Dale Randall

07-18-2003 04:36 AM
Dale Randall

Look here for info http://www.alldata.com/recalls/index.html "Ron" <jake.the.dogDELETETHIS (AT) charter (DOT) net> wrote

Maz

07-18-2003 12:16 AM
Maz

but how do you know when a rod is knocking? -- Tater President of MARS Club www.treece.org/mars.htm NAR #79654 L1 AMA #747769 EAA #703312 remove...

Chap

07-17-2003 10:43 PM
tater schuld

Well, it's definately the truck then. I would keep testing up the line to find the problem. I would guess that the last connector is faulty or...

Ron

07-17-2003 09:06 PM
RB

Can I use a 351M harmonic balancer on a 351W? I think they weight is supposed to be the same, but the internal placement of weights could...

Joshua P Luben

07-17-2003 04:03 PM
Joshua P Luben

I have recently replaced the engine in a my f150. I went from a 5.0 to a 5.8. When I got the the new (used) Ecu it was the wrong one. I have found...

Mbaker3039

07-17-2003 03:56 PM
Mbaker3039

Also forgot to add the electricity for the engine block heater. That is rated at 1KW, so if you have to use it a lot in the winter the cost of...

news.verizon.net

07-17-2003 01:02 PM
Martin Rogoff

I recently got a Ford 2001 F150. Excellent condition. No body work at all, no modifications of any kind. What I found on my first night ride was...

EFK

07-16-2003 09:50 PM
EFK

The heater/AC fan switch, normally four speeds, only works in positions 1, 3, and 4, Position 2 is no change in speed from position 1. Any tips...

Lee K

07-16-2003 07:06 PM
Steve Barker

tiredofthis12001 (AT) yahoo (DOT) com (Don) started a controversy when he said in news:e647cf2.0307091133.5030bdba (AT) posting (DOT) google.com: I...

Robotron Tom

07-16-2003 05:52 PM
Lee K