Yesterday, my 1998 Ford Explorer had a difficult time starting, as if
the battery was low on juice. I jump started it with cables to get me
to work. Several times during the day, it had difficulty turning over.
This morning, I cleaned the battery cables and terminals since the
negative was corroded. I made the cable ends and battery terminals
clean and shiny to insure good connections. While the engine was
running, I disconnected the postive cable and measured around 14 volts
off of the positive cable to ground, so I assume the alternator and
voltage regulator are working. However, on my way to work, I noticed
the turn signals were not working. The truck still started after
shutting it off, but I measured the voltage on the battery and I get
around 10.5 volts, which is low.

So, do I just need a new battery and the turn signals not working are
a coincidence? Could I have a bad turn signal switch or relay? I
cannot determine which fuse is for the turn signals. The manual does
not have the turn signals on the fuse list.

Roger Baker wrote:
Does your Explorer have grooves on the roof running the full lentgh of
the car? The grooves are about four inches from the edge on both sides.
If you do, they have a tendency to leak around the top of the windshield
right at the top. The water will run down the pillar post and onto the
main fuseblock behind the dash. The fuse block gets rusty and screws up
electrical system.. It's an easy fix, a 10mm sockat and the fuse block
comes right out...
--
Skype <fxdlrider2>

On Nov 4, 12:03*pm, Old Harley Rider <roninfl... (AT) yahoo (DOT) com> wrote:
I believe that I do. I have had leaks and I actually put some black
eletrical tape along some seams at the top. I was getting water in the
very back corner of the vehicle, but I wasn't sure exactly where it
was leaking. So, taking out the main fuse block, which is on the side
of the dash will reveal something? (Not the fuses under the hood). I
will go take a look now if the tools I brought to work can handle it.

On Nov 4, 12:16*pm, Roger Baker <rogba... (AT) gmail (DOT) com> wrote:
As far as I can tell, the fuseblock seems okay. I did not get a great
view inside the back though. I just noticed that the high beams do not
switch on, so the multifunction switch is probably bad. I wonder how
easy it is to change that.

On Nov 4, 10:02*am, Roger Baker <rogba... (AT) gmail (DOT) com> wrote:
NEVER unhook a battery cable while the engine is running. It's a good
way to destroy lots of electronics.
You could do it with a generator, but don't do it with an alternator.