Good day all. My question isn’t technical by any means but rather an
easier method. I need to replace my drivers door latch on my 99
taurus. I get most of it apart but when it comes to taking apart the
rods n’ such on the old latch, i can’t get a reach on it. Looks like
they built the thing around the latch, am I missing something or
overlooking something here?

--
Posted using the http://www.autoforumz.com interface, at author's request
Articles individually checked for conformance to usenet standards
Topic URL: http://www.autoforumz.com/Ford-Mecur...ict124561.html
Visit Topic URL to contact author (reg. req'd). Report abuse: http://www.autoforumz.com/eform.php?p=606433

alten78 wrote:
Is the lower window run channel in the way? IIRC, on your Taurus, you can pull the
rubber window run out, remove a bolt on the bottom of the channel and pull the channel
down and out. On some you don't have to remove the rubber from the channel, it's
separate from the upper section. This opens it up a lot. Door latches can be hours of
"entertainment" if you haven't done many.