AutosTalk Forums  

1992 Buick Regal -- How do I read the Codes?

General Motors Discussions About General Motors vehicles (alt.autos.gm)


Discuss 1992 Buick Regal -- How do I read the Codes? in the General Motors forum.



Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old   
Deeky
 
Posts: n/a

Default 1992 Buick Regal -- How do I read the Codes? - 08-22-2004 , 10:32 PM






Is there a jumper I must short or what to read Codes from this machine? My
grandmother has had her engine light lit for some time, and I don't think
her garage has figured it out?!?

Also, for several years the Check Guages indicator is lit. What exactly
trips that, is it an individual signal from each guage or fed from a
computer somewhere?

Nice little car, 60,000 miles.

Any sites or assistance appreciated.

Thanks.

Deacon Eisenhart



Reply With Quote
  #2  
Old   
Bjorntoluz
 
Posts: n/a

Default Re: 1992 Buick Regal -- How do I read the Codes? - 08-23-2004 , 12:45 AM






Quote:
Is there a jumper I must short or what to read Codes from this machine?
According to the Haynes Repair Manual, "on some OBD 1 models with a 12-pin Data
Link Connector, trouble codes can be accessed by connecting terminal B with
terminal A with a jumper wire with the ignition key in the ON position and the
codes can be read by watching the flashes of the SERVICE ENGINE SOON light."

Do not crank or start the engine when terminals A and B are connected, the ECM
could be damaged.

The pin layout is F E D C B A
G H J K L M

A is ground, B is the diagnostic test terminal.

The book also says that some models with the 12-pin connector do not have a
terminal B present. In that case you'll need a scan tool.

Quote:
the Check Guages indicator is lit. What exactly
trips that
No idea.

good luck




Reply With Quote
  #3  
Old   
80 Knight
 
Posts: n/a

Default Re: 1992 Buick Regal -- How do I read the Codes? - 08-23-2004 , 03:23 AM



I can tell you that I have owned 2 Pontiac Grand Prix's, a 1991 and a 1992,
and both had dash lights on that were on for no reason. I heard that dash
boards of that era were faulty at times, such as on my cars, where the Check
Gauges and Low Fuel lights were on all the time. Also, the Oil Pressure
gauge did not work on either car, and does not work on my '91 Bonnie either.

--
80 Knight
My Karr's Website:
http://www.geocities.com/brandon_80_knight/


"Deeky" <d.eisenhart (AT) verizon (DOT) net> wrote

Quote:
Is there a jumper I must short or what to read Codes from this machine?
My
grandmother has had her engine light lit for some time, and I don't think
her garage has figured it out?!?

Also, for several years the Check Guages indicator is lit. What exactly
trips that, is it an individual signal from each guage or fed from a
computer somewhere?

Nice little car, 60,000 miles.

Any sites or assistance appreciated.

Thanks.

Deacon Eisenhart





Reply With Quote
  #4  
Old   
Robert Hancock
 
Posts: n/a

Default Re: 1992 Buick Regal -- How do I read the Codes? - 08-24-2004 , 10:47 PM



Some GM vehicles had problems with the cluster-controlled lights such as
Check Gauges behaving erratically because of bad solder joints on the
cluster PCB, but the Check Engine light is always controlled directly by the
ECM.

--
Robert Hancock Saskatoon, SK, Canada
To email, remove "nospam" from hancockr (AT) nospamshaw (DOT) ca
Home Page: http://www.roberthancock.com/


"80 Knight" <80_knightREMOVE_ME_PLEASE (AT) rogers (DOT) com> wrote

Quote:
I can tell you that I have owned 2 Pontiac Grand Prix's, a 1991 and a 1992,
and both had dash lights on that were on for no reason. I heard that dash
boards of that era were faulty at times, such as on my cars, where the
Check
Gauges and Low Fuel lights were on all the time. Also, the Oil Pressure
gauge did not work on either car, and does not work on my '91 Bonnie
either.

--
80 Knight
My Karr's Website:
http://www.geocities.com/brandon_80_knight/


"Deeky" <d.eisenhart (AT) verizon (DOT) net> wrote in message
news:v56dnTdaafjc-LTcRVn-hA (AT) suscom (DOT) com...
Is there a jumper I must short or what to read Codes from this machine?
My
grandmother has had her engine light lit for some time, and I don't think
her garage has figured it out?!?

Also, for several years the Check Guages indicator is lit. What exactly
trips that, is it an individual signal from each guage or fed from a
computer somewhere?

Nice little car, 60,000 miles.

Any sites or assistance appreciated.

Thanks.

Deacon Eisenhart







Reply With Quote
Reply




Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.