 | |
E.C.U Flash codes Rover 216 (1993) Honda engine
Honda/Acura Vehicles Discussion group for Honda/Acura vehicles. (alt.autos.honda)
 |
| | Thread Tools | Search this Thread | Display Modes |
#1
 
| |||
| |||
|
E.C.U Flash codes Rover 216 (1993) Honda engine -
07-29-2003
, 05:23 PM
#2
| |||
| |||
|
|
Can anyone supply ecu flash codes for a rover 216 with the honda pgm fi unit. My engine check light comes on after about 15 minutes travelling, The car still functions ok but the idle is a bit rough.I also want to reset this ecu as i think it is showing more than one code. I have pulled the fuse for this (by the drivers right knee)for about 30 minutes but it did not clear it Thanks Gary |
fuse in the engine compartment fuse box. It mentions an ECU fuse in
the driver compartment in a list a the back of the book, but the
written section on resetting mentions the 10amp hazard warning one in
the engine compart.
#3
| |||
| |||
|
|
On 29 Jul 2003 14:23:27 -0700, gaz (AT) speed-mail (DOT) co.uk (Gary) wrote: Can anyone supply ecu flash codes for a rover 216 with the honda pgm fi unit. My engine check light comes on after about 15 minutes travelling, The car still functions ok but the idle is a bit rough.I also want to reset this ecu as i think it is showing more than one code. I have pulled the fuse for this (by the drivers right knee)for about 30 minutes but it did not clear it Thanks Gary According to my Haynes manual you reset the ECU by removing the 10Amp fuse in the engine compartment fuse box. It mentions an ECU fuse in the driver compartment in a list a the back of the book, but the written section on resetting mentions the 10amp hazard warning one in the engine compart. |
flashes at all) upon restarting the car it would not idle, I had to
increase the tick over speed
#4
| |||
| |||
|
|
"Brian Gunn" <brian (AT) clare1980 (DOT) plus.com> wrote That's right - take the "Hazard" fuse out in the engine bay fusebox for 10s... Brian. What codes are you getting from the ecu btw? check engine light that comes on after 15mins of driving could well be a code 1 - it'll look like the light is flashing repeatedly, but in reality it's doing flash-pause-flash-pause-flash etc as it repeats the code.. tell us what code you get and then we can see.. Brian. "Trickle" <trickle (AT) nooneownsthisatfreeserve (DOT) fsnet.co.uk> wrote in message news:1h2liv062v6fktrds0h8j6mkgshsnv7qgu (AT) 4ax (DOT) com... On 29 Jul 2003 14:23:27 -0700, gaz (AT) speed-mail (DOT) co.uk (Gary) wrote: Can anyone supply ecu flash codes for a rover 216 with the honda pgm fi unit. My engine check light comes on after about 15 minutes travelling, The car still functions ok but the idle is a bit rough.I also want to reset this ecu as i think it is showing more than one code. I have pulled the fuse for this (by the drivers right knee)for about 30 minutes but it did not clear it Thanks Gary According to my Haynes manual you reset the ECU by removing the 10Amp fuse in the engine compartment fuse box. It mentions an ECU fuse in the driver compartment in a list a the back of the book, but the written section on resetting mentions the 10amp hazard warning one in the engine compart. Yes I pulled the hazzard fuse and this reset the ecu (there were no flashes at all) upon restarting the car it would not idle, I had to increase the tick over speed. I went out for a short drive and the check light came on, pulled the carpet back and yes you are correct it's flash-pause-flash-pause-flash, so what does this mean? Thanks for the advice. |
|
« Previous Thread
|
Next Thread »
| Thread Tools | Search this Thread |
| Display Modes | |
Linear Mode
| |
Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.