so i have been lazy, the starter on my passport went out, tried to replace
it myself and that stupid exhaust bolt got in the way. Thats as far as i
got. So i guess my questions would be...
1. Whats best to get the bolt off? Any suggestions? its like rusted tight
on there.

2. If its been sitting for two years and hasn't been started what damage
am i looking at from just leaving it sit?

Thanks!

Hi Eyeless,
Sitting for 2 years! I think the first thing I'd do is take the plugs all
out & give each cylinder a good squirt of WD-40 or like. I'd let it sit like
that for a bit, then with the plugs still out I'd turn it over by hand,
using a socket on the drive pulley or by using the fan blades as leverage
give it a few easy roll overs. Check your distributor for corrosion & use
fresh gas to get it started. As far as the bolt problem I don't know what
the configuration is & really can't say but where there's a will, there
usually is a way.
BCinBC
"eyeless" <midtownrugby (AT) yahoo (DOT) com> wrote