AutosTalk Forums  

2001 Grand Cherokee Laredo - rotors & tires

Jeep and Willys Vehicles Discussions on Jeep and Willys vehicles. (rec.autos.makers.jeep+willys)


Discuss 2001 Grand Cherokee Laredo - rotors & tires in the Jeep and Willys Vehicles forum.



Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old   
Phil Schuman
 
Posts: n/a

Default 2001 Grand Cherokee Laredo - rotors & tires - 05-01-2005 , 12:41 PM






I've read about all the problems with Jeep brake rotors,
and yup - we've been there at around 30k miles.
Now it's 15k miles more & starting with the shaking....

The rotors were turned the last time I was in at 30k,
so this time it's gonna be rotor replacement.....
Comments on going back to Jeep for replacement,
or going to any of the other car service places in the area....
Midas, etc -

Also - need a front end alignment, as the right front tire
is worn on one side, and the Jeep pulls to the right.
The Jeep has 45k miles on original tires, should we :
A - pull the worn for a spare, and use the full size spare ?
B - replace both front tires at the same time
C - rotate front to back
D - other

tnx for the comments and discussion....




Reply With Quote
  #2  
Old   
DougW
 
Posts: n/a

Default Re: 2001 Grand Cherokee Laredo - rotors & tires - 05-01-2005 , 01:04 PM






Phil Schuman did pass the time by typing:
Quote:
I've read about all the problems with Jeep brake rotors,
and yup - we've been there at around 30k miles.
Now it's 15k miles more & starting with the shaking....

The rotors were turned the last time I was in at 30k,
so this time it's gonna be rotor replacement.....
Comments on going back to Jeep for replacement,
or going to any of the other car service places in the area....
Midas, etc -
Just one.. stay the hell away from midas. I don't know
where they get their "ASE" certified monkeys but my and
other folks experience with them has been pitiful.
They actually tried to convince me of a leak in the rear
drum piston, pointing out the teeny bit of assembly lube
on the rubber cup. That and one of the monkeys there was
going to weld (YES, WELD) on a pin cause "the shoe they
gave me didn't have one liek yers doz". Well, DUH, that's
because you have the WRONG PART YOU MORON... put the parts
back on myself and left. And to think I went there to save
a bit of time and could have left with a rolling deathtrap.

</soapbox>

Anyhoo, rotors and pads are easy, real easy.
NAPA has them. Or you could go stillen if you
want to part with the dough.
http://www.nagca.com/grandtech/still...akeupgrade.htm


Quote:
Also - need a front end alignment, as the right front tire
is worn on one side, and the Jeep pulls to the right.
The Jeep has 45k miles on original tires, should we :
A - pull the worn for a spare, and use the full size spare ?
B - replace both front tires at the same time
C - rotate front to back
D - other
Which side of the tire, inside/outside?

Gonna need some more information.
2WD or 4WD
Transfer case:
Limited Slip on rear: Y/N

If the tires never have been rotated then
you may be better off getting an alighnment
and four new tires. I say that because having
oddball sized tires on a Jeep can damage the
drivetrain and/or cause "deathwobble" (on the front)
All depends on what your drivetrain is.

A little pull right is "normal" on roads that have
a steep crown, but on a flat surface you shoud track
straight. Have you checked the recalls for your Jeep
just be sure there are no suspension/steering issues?


--
-- DougW -- 93 ZJ 4.0 http://members.cox.net/wilsond
HESCO Supercharger - 300W IASCA Stereo - Edelbrock IAS Shocks
Gibson Exhaust - rear DCpower - custom gauge install - Stillen Rotors
Banks Header - and BEER, in the fridge!




Reply With Quote
Reply




Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.