Hello,

Thanks for the help everyone with my oil pressure problem. I found
that it is the oil sending unit as expected.

The problem is that the wire/connector going into it is popping out.
It is connected but it has like a little rubber thing that slides into
the top of it with thte 2 wires going through it. I can push it back
in and then when the jeep is cranked it pops back out and out comes
the oil oozing.. My problem is I followed it back just a bit and it
is connectoed to other wire that run somewhere else. Anyone have an
idea how I will change that piece.
I hope I explained it ok.. If it doesn't make sense I will try to
explain it differently..

thanks again..!!!!

Shawn..

Wow !!! bad typing on the subject of the posting.. Sorry .. My laptop
keyboard was acting crazy!! I'm really not that dumb!!

Shawn

Here is a link to a picture of what's going on.. Don't laugh to hard..
but if you have ever seen what I am talking about I think the picture
will make sense.. !!
http://www.monkeysuncle.com/sending.gif

Thanks Again!!


Shawn


On Tue, 29 Mar 2005 19:45:20 -0500, Shawn <dingle71@@@yahoo.com>
wrote:

Shawn did pass the time by typing:
The sender is bad.

What's happening is the little metal diaphram in there has sprung a leak
and oil is getting through. That pressure buildup is popping the connector
off. You need a new sensor.

--
DougW

The wires stay with the Jeep, you need the metal part, the sender.

Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's

Shawn wrote: