seeking a mini

#21

Good idea. I'll give that a try. Thanks for the tip.

--
Clive

ICQ 36890776
www.minisquad.tk
"Steve68s" <steve68s(remove)@btinternet.com> wrote

Quote:

no, you can back the nuts of on the adjusters on the rocker arms & move
them on the rocker shaft if its not to gummed up,

Steve.

"Clive W" <minimanclive (AT) hotmail (DOT) com> wrote in message
news:dcqqu7$gvn$1 (AT) newsg3 (DOT) svr.pol.co.uk...
I know for sure there's excessive wear on the bottoms of the
pushrods.(It's just as descibed on the Mini Spares website) I don't think
the rockers aren't too bad. Although it's been more rattley since I set
the valve clearances to the correct gaps for the MG Metro cam it's got.

Changing the push rods is going to mean a head gasket change as well
isn't it as i'll have to undo four of the cylinder head nuts?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

seeking a mini

Mini Discussion of English Mini automobiles (alt.autos.mini)

Re: seeking a mini -update- - 08-03-2005 , 01:35 PM