AutosTalk Forums  

Removing Nokia Car Kit from a car

Miscellaneous UK car topics Other UK car topics (uk.rec.cars.misc)


Discuss Removing Nokia Car Kit from a car in the Miscellaneous UK car topics forum.



Reply
 
Thread Tools Display Modes
  #1  
Old   
Steve Bilton
 
Posts: n/a

Default Removing Nokia Car Kit from a car - 09-02-2004 , 09:42 AM






How easy is it to remove a Nokia car kit?

I need to remove one on Monday evening from a 406 estate. It uses the
the velcro mic and the external speaker - so no connection to the cars
stereo - and also a tax-disc aerial.

Is it just a case of disconnect the aerial, mic and speaker and pull
the cables through, then disconnect the power feed?
All help will be gratefully appreciated.

SteveB


Reply With Quote
  #2  
Old   
David Thornber
 
Posts: n/a

Default Re: Removing Nokia Car Kit from a car - 09-02-2004 , 04:09 PM






In message <ch7bgs$j9q (AT) odak26 (DOT) prod.google.com>, Steve Bilton
<steve.bilton (AT) gmail (DOT) com> writes
Quote:
How easy is it to remove a Nokia car kit?

I need to remove one on Monday evening from a 406 estate. It uses the
the velcro mic and the external speaker - so no connection to the cars
stereo - and also a tax-disc aerial.

Is it just a case of disconnect the aerial, mic and speaker and pull
the cables through, then disconnect the power feed?
All help will be gratefully appreciated.

I've installed a couple of genuine Nokia kits (a CARK-91, and I forget
the model name of the other one.) The power, mic, cradle and speaker
all connect to a controller unit, which will probably be hidden away
somewhere. The antenna feed goes straight to a separate flying lead
from the cradle.

As long as you can locate the controller, you stand a chance of pulling
the wires through, though they're likely to have been tie-wrapped to
other wiring or fittings for security and neatness. You'll also need to
work out where the power feeds and ground are hooked in, unless you're
prepared to crop the wires. If you do crop the wires, you'll need to
make sure you connect via appropriate value fuses when re-installing. I
should be able to look up the details for you if you need them. The
power wires connect to the controller by a white multi-pole block
connector, while the mic/speaker use jack plugs and the cradle uses
(IIRC) something akin to a huge ethernet/phone type connector. By all
means consider cropping the power wires if needed, but don't go lopping
away at any of the others.

Of course this assumes that you're planning on re-installing the kit in
another car. If you just want to restore the current car to its
original pre-installed appearance, then it should be a lot easier.
--
David Thornber


Reply With Quote
  #3  
Old   
Steve Bilton
 
Posts: n/a

Default Re: Removing Nokia Car Kit from a car - 09-03-2004 , 03:28 AM



David,

Many thanks.

The car is going back on Tuesdy hence the need to remove on Monday.

I would be looking to install it to a pre wired Zafira and understand
that I can get a new cable that will plug into the loom on the Zafira,
and presumably into the control box?

Thanks again

SteveB


Reply With Quote
  #4  
Old   
David Thornber
 
Posts: n/a

Default Re: Removing Nokia Car Kit from a car - 09-03-2004 , 05:47 AM



In message <ch99v4$9vi (AT) odah37 (DOT) prod.google.com>, Steve Bilton
<steve.bilton (AT) gmail (DOT) com> writes
Quote:
David,

Many thanks.

The car is going back on Tuesdy hence the need to remove on Monday.

I would be looking to install it to a pre wired Zafira and understand
that I can get a new cable that will plug into the loom on the Zafira,
and presumably into the control box?

I'm not sure how Vauxhall do it. If you can get a wiring harness (I
know Renault won't sell you one without the full car kit) you'll
probably find that it provides direct connections for the mic, speaker
and antenna. Unless Vauxhall do a specific Nokia cable, you'll be
expected to mate individual power, ground and stereo mute wires with the
wires on the multi-plug for the Nokia module. Don't be surprised if the
colour coding is different between the Nokia and Vauxhall wiring.

I'd also recommend deviating from the 'official' Nokia wiring while you
have the chance. The Nokia kits usually have two power inputs - one for
permanent live and the other for ignition live, but if you wire them up
as you're supposed to, your phone will switch off about 30 seconds after
you stop the engine. If you don't want it to do that, just wire them
both to permanent live.

--
David Thornber


Reply With Quote
  #5  
Old   
noman
 
Posts: n/a

Default Re: Removing Nokia Car Kit from a car - 09-04-2004 , 06:14 PM




"David Thornber" <dthornber (AT) scancoin (DOT) co.uk> wrote

Quote:
In message <ch99v4$9vi (AT) odah37 (DOT) prod.google.com>, Steve Bilton
steve.bilton (AT) gmail (DOT) com> writes
David,

Many thanks.

The car is going back on Tuesdy hence the need to remove on Monday.

I would be looking to install it to a pre wired Zafira and understand
that I can get a new cable that will plug into the loom on the Zafira,
and presumably into the control box?

I'm not sure how Vauxhall do it. If you can get a wiring harness (I know
Renault won't sell you one without the full car kit) you'll probably find
that it provides direct connections for the mic, speaker and antenna.
Unless Vauxhall do a specific Nokia cable, you'll be expected to mate
individual power, ground and stereo mute wires with the wires on the
multi-plug for the Nokia module. Don't be surprised if the colour coding
is different between the Nokia and Vauxhall wiring.

I'd also recommend deviating from the 'official' Nokia wiring while you
have the chance. The Nokia kits usually have two power inputs - one for
permanent live and the other for ignition live, but if you wire them up as
you're supposed to, your phone will switch off about 30 seconds after you
stop the engine. If you don't want it to do that, just wire them both to
permanent live.

--
David Thornber
I don't want to hijack the posting but I've a factory fit Nokia kit fitted
to my Nissan Micra for a 3330 but would like to get it to take my 6100. Any
way convert it with an adapter or will it only work with a 3??? nokia phone?

Noman




Reply With Quote
  #6  
Old   
Questions@quickwatchsales.com
 
Posts: n/a

Default Re: Removing Nokia Car Kit from a car - 09-05-2004 , 06:31 PM



Apparently on date Sun, 5 Sep 2004 00:14:21 +0100, "noman" <nospam (AT) hotmail (DOT) com>
said:

Quote:
I don't want to hijack the posting but I've a factory fit Nokia kit fitted
to my Nissan Micra for a 3330 but would like to get it to take my 6100. Any
way convert it with an adapter or will it only work with a 3??? nokia phone?
Probably not, Nokia list different kits.






Reply With Quote
  #7  
Old   
David Thornber
 
Posts: n/a

Default Re: Removing Nokia Car Kit from a car - 09-06-2004 , 03:23 PM



In message <2pv0ihFp8l6fU1 (AT) uni-berlin (DOT) de>, noman <nospam (AT) hotmail (DOT) com>
writes
Quote:
I don't want to hijack the posting but I've a factory fit Nokia kit fitted
to my Nissan Micra for a 3330 but would like to get it to take my 6100. Any
way convert it with an adapter or will it only work with a 3??? nokia phone?

If you believe the Nokia bumf, then you can buy the cradle for the 6100
and just hook it up to the controller unit in place of your existing
cradle. I've never actually seen it done though, and never found anyone
selling anything but the complete kit, but it's worth asking around.

It might be worth looking out for used 6000 series kits on eBay or at
car boot sales, as you can sometimes pick them up for buttons. As
above, you should be able to get away with just connecting the cradle to
the existing controller.
--
David Thornber


Reply With Quote
  #8  
Old   
Tim \(Remove NOSPAM.
 
Posts: n/a

Default Re: Removing Nokia Car Kit from a car - 09-09-2004 , 03:39 AM




"noman" <nospam (AT) hotmail (DOT) com> wrote


Quote:
I don't want to hijack the posting but I've a factory fit Nokia kit fitted
to my Nissan Micra for a 3330 but would like to get it to take my 6100.
Any
way convert it with an adapter or will it only work with a 3??? nokia
phone?

All you need do is change the cradle for one for a 6xxx series fone.

Tim..




Reply With Quote
  #9  
Old   
noman
 
Posts: n/a

Default Re: Removing Nokia Car Kit from a car - 09-09-2004 , 09:38 AM



" Tim (Remove NOSPAM." <the.farm (AT) NOSPAMbtinternet (DOT) com> wrote

Quote:
"noman" <nospam (AT) hotmail (DOT) com> wrote in message
news:2pv0ihFp8l6fU1 (AT) uni-berlin (DOT) de...

I don't want to hijack the posting but I've a factory fit Nokia kit
fitted
to my Nissan Micra for a 3330 but would like to get it to take my 6100.
Any
way convert it with an adapter or will it only work with a 3??? nokia
phone?

All you need do is change the cradle for one for a 6xxx series fone.

Tim..


What about the connections?Aren't the connections separate from the cradle.
If not where would I buy a cradle with connections for a 6100.

Noman




Reply With Quote
Reply




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Powered by vBulletin
Copyright ©2000 - 2010, Jelsoft Enterprises Ltd.