![]() | |
![]() |
| | Thread Tools | Display Modes |
#1
| |||
| |||
|
|
One of my headlights burned out on my 2002 Altima. I checked the owner's manual on replacing the bulb (NOT a XENON bulb - just a halogen) and it stated that the bulb change should be completed by the dealer...are they kidding? Has anyone done this before, or is it THAT complicated? Any info would be helpful. Thanks. |
#2
| |||
| |||
|
|
On the left front head lamp, I checked into this and found that alot of work would have to be done - looked like most of the bumper would need to be removed. I took the vehicle to the dealer and was quoted 1.5 hrs labor to change the lamp. I called Nissan to voice a complaint about the design of the car that would require this much labor to change a headlamp bulb. They were not very sympathetic and even mentioned that "this was life" - "the design was good" - etc. On the right front head lamp, the bulbs are easier to get to with no removal of plastics required. I am thoroughly disgusted with Nissan concerning this. "Perky" <dwcperkie (AT) hotmail (DOT) com> wrote in message news:aqtp4056ppqtimeui2nbcleclu89jkq7rv (AT) 4ax (DOT) com... One of my headlights burned out on my 2002 Altima. I checked the owner's manual on replacing the bulb (NOT a XENON bulb - just a halogen) and it stated that the bulb change should be completed by the dealer...are they kidding? Has anyone done this before, or is it THAT complicated? Any info would be helpful. Thanks. |
#3
| |||
| |||
|
#4
| |||
| |||
|
|
Had my left side buld go out. Read a lot of scary posts about labor, etc. to get it replaced. Took it to my mechanic, who charged me $15 for the bulb, and threw in the labor for free. I was having other stuff done at the time (trans flush, brakes), so I guess that helped. Point being...it probably wasn't THAT MUCH of a big job when they didn't charge me. Either that, or they really like me. |
#5
| |||
| |||
|
#6
| |||
| |||
|
|
I replaced driver's side low-beam last night in 35 minutes. Remove the air cleaner housing, twist counterclockwise and remove the white plastic cover from rear of headlamp assembly, and bulb replacement is quick and easy. To remove air cleaner housing, one bolt on left fender, uncouple from hose in front of housing, and lift out. You will have to pull hard because it is supported by two friction supports on bottom. |
#7
| |||
| |||
|
#8
| |||
| |||
|
#9
| |||
| |||
|
#10
| |||
| |||
|
![]() |
| Thread Tools | |
| Display Modes | |
| |