![]() | |
![]() |
| | Thread Tools | Display Modes |
#11
| |||
| |||
|
|
On Mar 30, 10:48 pm, "Chuck Tribolet" <trib... (AT) garlic (DOT) com> wrote: I don't think struts and springs are the problem. Jack the car up. Do the springs rattle when you shake them up and down? No? It's NOT springs. Struts? I can only see them making a noise if something is obviously loose, like the bolts at the top. Torque every bolt in the front end to factory spec. That means loosen it a bit, and then torque it with a torque wrench (I'd really like to have a wrench that's a torque wrench when tightening, and a normal wrench when loosening.) Find a place you can reproduce the problem. Have a buddy with good ears (no rock band fanatics) stand outside the car as you go by. Make sure it's coming from where you think it is. Have them stand on both sides of the car as you go by. Don't throw parts, labor, and money at the problem, find the problem. No: it's not springs. le... (AT) sympatico (DOT) ca> wrote in messagenews:3d878372-b57b-4d1f-8037-0fb8b4b2725e (AT) s50g2000hsb (DOT) googlegroups.com... On Mar 25, 8:57 pm, al <abuo... (AT) msn (DOT) com> wrote: On Mar 24, 5:10 pm, le... (AT) sympatico (DOT) ca wrote: I bought an 02 Sentra a few days ago. When I go over a slight bump or crack in the road (only at low speed) the right front wheel knocks very hard. I had the stabilizer links replaced, they had a little play in them, but the knock is still there. Any ideas ? Thanks. Leo Do you get any knocking sound if you rock the right front corner of the car up and down? If it's that noticeable, you might be able to reproduce it while stopped. You might examine the condition of the upper strut mounts. Good luck. Al No, everything is tight. I replaced the front engine mount, it was worn. I'm going to go for new struts and springs. I've had 2 mechanics go over the entire front end, removed, inspected and replaced (with same assembly) the right side strut assembly, but can't isolate the problem. The suspension is 6 years old, and I'm only paying cost for the parts, no labour charge. Less than $200.00 for everything. It can't hurt. I trust it will fix the problem. Thanks. Leo |
#12
| |||
| |||
|
#13
| |||
| |||
|
|
Couple of things. Loose wheel or incorrectly installed wheel. Clean hub and torque the wheel nuts. Outer CV shaft joint is moving in joint because the clip has come loose or missing. Disk Brake pads moving inside the calliper. Had that problem with a Ford Focus. The aftermarket pads backing plate was too large and when I went over a bump or accelerated/slowed I would get a knock. I was sure it was a drive shaft but after grinding a little off of the backing plates of the front pads the knock was gone. |
#14
| |||
| |||
|
|
On Mar 31, 1:56 pm, "G" <ginn... (AT) hotmail (DOT) com> wrote: Couple of things. Loose wheel or incorrectly installed wheel. Clean hub and torque the wheel nuts. Outer CV shaft joint is moving in joint because the clip has come loose or missing. Disk Brake pads moving inside the calliper. Had that problem with a Ford Focus. The aftermarket pads backing plate was too large and when I went over a bump or accelerated/slowed I would get a knock. I was sure it was a drive shaft but after grinding a little off of the backing plates of the front pads the knock was gone. Tomorrow I'm taking it into the shop again, we'll start with new struts and check every nut and bolt within the suspension system again. I checked the brakes last Sat., they were fine. I'll let you all know. Thanks everyone. Leo |
#15
| |||
| |||
|
|
On Apr 1, 12:10 am, le... (AT) sympatico (DOT) ca wrote: On Mar 31, 1:56 pm, "G" <ginn... (AT) hotmail (DOT) com> wrote: Couple of things. Loose wheel or incorrectly installed wheel. Clean hub and torque the wheel nuts. Outer CV shaft joint is moving in joint because the clip has come loose or missing. Disk Brake pads moving inside the calliper. Had that problem with a Ford Focus. The aftermarket pads backing plate was too large and when I went over a bump or accelerated/slowed I would get a knock. I was sure it was a drive shaft but after grinding a little off of the backing plates of the front pads the knock was gone. Tomorrow I'm taking it into the shop again, we'll start with new struts and check every nut and bolt within the suspension system again. I checked the brakes last Sat., they were fine. I'll let you all know. Thanks everyone. Leo The struts were finished, especially the right side. New one's made a big difference. There's still a slight knock which are likely the sway bushings. I'm changing them this Fri. Hope that's it. Be well. Leo |
![]() |
| Thread Tools | |
| Display Modes | |
| |