Nevermind - I see that you replaced both Crank angle sensors. Did you
reset the ECU after performing all those repairs?

Also, which plugs did you use when you replaced yours?

Nirav

The Crank Sensors were done by a friend. I'm not sure if he reset the
ECU... This is the Electronic Contorl Unit I'm assuming which times and
controls injection, idle speed, ignition timing, etc.? How woulld I
reset this unit?


njmodi wrote:

nick.drea.kurtz (AT) usfamily (DOT) net wrote:
How to get the code:
http://vbxmaxima.8m.com/ecu.html

What the code means:
http://vbxmaxima.8m.com/ecudecoder.html

You need to reset the ECU after replacing any parts that were detected
as faulty. It will eventually detect the replaced part is operating
per spec, but that takes a certain number of complete start/stop
cycles.

Nirav