![]() | |
![]() |
| | Thread Tools | Search this Thread | Display Modes |
#1
| |||
| |||
|
#2
| |||
| |||
|
|
All, The CEL set on my Max two weekends ago showing DTC 0210 (P0174). This indicates that the system detected the left bank was running lean. Possible faults: 1. MAF 2. Injector(s) 3. Air Intake leak 4. Bad O2 sensor 5. Exhaust leak My diagnosis: 1. MAF -> Nope - would likely affect both banks - car runs and pulls fine. 2. Injector(s) -> Nope - listened to each injector (left bank is the front 3 cylinders on the VQ30DE) - each clicks normally and at the same frequency. Also, I didn't get any misfire code or feel any hestitation when driving - so I'm pretty sure it's not one or more injectors... 3. Air Intake leak -> Nope: I had the top of the engine off two years ago when replacing the valve cover spark plug seals and I replaced the upper-intake- manifold gasket as well as all other intake assembly gaskets. Also I'd expect this to affect both banks. 4. Bad O2 sensor -> Most likely. O2 sensors are 60k old - mileage has been down about 10% over the past few months (before CEL tripped) 5. Exhaust leak -> Nope: Didn't feel anything upstream of the O2 - no noise. So before I order myself a new O2 sensor to swap in -> anyone else have any thoughts or comments on my reasoning, or experience with this fault? I'm too lazy to swap the two front O2 sensors around to see if I can move the fault to the other bank ![]() I know on the 5th Gens, system lean codes for both banks would show up at the same time, and that was usually the MAF... Note: Resetting the ECU (to clear CEL) keeps it off for sometimes a few days, sometimes a few hours. Thanks, Nirav |
#3
| |||
| |||
|
|
On May 21, 1:44 pm, njm... (AT) gmail (DOT) com wrote: All, The CEL set on my Max two weekends ago showing DTC 0210 (P0174). This indicates that the system detected the left bank was running lean. Possible faults: 1. MAF 2. Injector(s) 3. Air Intake leak 4. Bad O2 sensor 5. Exhaust leak My diagnosis: 1. MAF -> Nope - would likely affect both banks - car runs and pulls fine. 2. Injector(s) -> Nope - listened to each injector (left bank is the front 3 cylinders on the VQ30DE) - each clicks normally and at the same frequency. Also, I didn't get any misfire code or feel any hestitation when driving - so I'm pretty sure it's not one or more injectors... 3. Air Intake leak -> Nope: I had the top of the engine off two years ago when replacing the valve cover spark plug seals and I replaced the upper-intake- manifold gasket as well as all other intake assembly gaskets. Also I'd expect this to affect both banks. 4. Bad O2 sensor -> Most likely. O2 sensors are 60k old - mileage has been down about 10% over the past few months (before CEL tripped) 5. Exhaust leak -> Nope: Didn't feel anything upstream of the O2 - no noise. So before I order myself a new O2 sensor to swap in -> anyone else have any thoughts or comments on my reasoning, or experience with this fault? I'm too lazy to swap the two front O2 sensors around to see if I can move the fault to the other bank ![]() I know on the 5th Gens, system lean codes for both banks would show up at the same time, and that was usually the MAF... Note: Resetting the ECU (to clear CEL) keeps it off for sometimes a few days, sometimes a few hours. Thanks, Nirav When I had my 98 Maxima, I put a performance catalyst into it, and I vaguely recall getting a similar CEL code. Putting the OEM cat back resolved it. So maybe there's something going on with your cat. CD |
#4
| |||
| |||
|
|
All, The CEL set on my Max two weekends ago showing DTC 0210 (P0174). This indicates that the system detected the left bank was running lean. Possible faults: 1. MAF 2. Injector(s) 3. Air Intake leak 4. Bad O2 sensor 5. Exhaust leak My diagnosis: 1. MAF -> Nope - would likely affect both banks - car runs and pulls fine. 2. Injector(s) -> Nope - listened to each injector (left bank is the front 3 cylinders on the VQ30DE) - each clicks normally and at the same frequency. Also, I didn't get any misfire code or feel any hestitation when driving - so I'm pretty sure it's not one or more injectors... 3. Air Intake leak -> Nope: I had the top of the engine off two years ago when replacing the valve cover spark plug seals and I replaced the upper-intake- manifold gasket as well as all other intake assembly gaskets. Also I'd expect this to affect both banks. 4. Bad O2 sensor -> Most likely. O2 sensors are 60k old - mileage has been down about 10% over the past few months (before CEL tripped) 5. Exhaust leak -> Nope: Didn't feel anything upstream of the O2 - no noise. So before I order myself a new O2 sensor to swap in -> anyone else have any thoughts or comments on my reasoning, or experience with this fault? I'm too lazy to swap the two front O2 sensors around to see if I can move the fault to the other bank ![]() I know on the 5th Gens, system lean codes for both banks would show up at the same time, and that was usually the MAF... Note: Resetting the ECU (to clear CEL) keeps it off for sometimes a few days, sometimes a few hours. Thanks, Nirav |
![]() |
| Thread Tools | Search this Thread |
| Display Modes | |
| |