I replaced my crank shaft pulley and belts on my 95 maxima

now the whol car shakes in the lower RPM range, maby timeing problems,

what coud lit be? It has to be rel;ated to this pulley instalation

thnak you for any help!

Clayton Swikert wrote:

Did you buy OEM Nissan belt and parts?

Clayton Swikert wrote:

Hello,

Make sure you got the right pulley and lined up the key way hole on the
crank with the slot on the pulley. It is possible that the crank position
sensor can not read the pully or the pully is out of round. I would
recommend getting a factory one if you didn't.

Why did you have to replace the pully. I have not seen any go bad in my 10
yrs with nissan.

Hope this helps

Mark - owner of the Nissan Help website
http://nissanhelp.cjb.net

"Clayton Swikert" <RedfoxXx (AT) tampabay (DOT) rr.com> wrote

Thank you for your help!

i dident use a verry good torq wrench, all is better now!