Hi,

i finally had some time at home to set up my new comp and so far its runnign great!
i come back with one question, what would be the best way to route a power cable to the trunk?
it is going to be a pretty thick cable as i want to install a 400W sine wave inverter and a 100W(real watts) amp in there. i am not sure if i will be able to fit it in the channel that goes under the doorstep covers and how to get it into the engine compartment, also what is the best point to connect it to the circuit, right at the battery terminals or where? should i run the negative wire to the front too or is it okay to hook it up somewhere on the chassis?

bye

simon

On Mon, 30 Jun 2003 16:54:28 GMT
'nuther Bob <<none (AT) none (DOT) com>> wrote:

that would be the first genuine saab welder then, i guess
damn i must have slipped into too many peoples killfiles until now.
oh well more time to work on my kreidler then.

bye

simon