 | |
Re: Rear sway-bar and brake line routing...
Saturn cars All about Saturn cars, fans and company. (rec.autos.makers.saturn)
 |
| | Thread Tools | Display Modes |
#1
 
| |||
| |||
|
Re: Rear sway-bar and brake line routing... -
07-02-2003
, 09:14 PM
|
I don't think the brakeline should touch anything but it's holders and fittings. Disconnect the anti-sway-bar ends lube the bar next to the bushings, same side of each bushing, twist the bar end up & down while pushing the bar side to side in the car. May need to loosen the bushing clamps. Reconnect bar ends, and tighten clamps if needed. This way not everything needs to come apart. I hope this is of some help. "Jonnie Santos" <see_contact.gif (AT) jonniesantos (DOT) com> wrote in message news:5KsMa.58087$1e.44326 (AT) fed1read04 (DOT) .. re: 97SL2 Is the solid, bentline rear brake line supposed to ride against the sway-bar up in the channel that runs from each side of the car, or is there supposed to be some space? Also, I have urethane bushings on the bar - I hate the squeak and the grease I have looks like I have to take everything apart to lube the bushings - any suggestions? |
|
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
Powered by vBulletin
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.