If I owned a Honda, I'd be able to buy a cable that simply plugs into
the CD-changer port, which then gives the stock head unit an
auxiliary-input jack/capability.

Is there any way to do the same thing with the head unit that comes
stock in Subaru 95-99 Legacy L?
Thanks.

"PCB" <not (AT) this (DOT) time.mil> wrote

I am).

Jon

Wasn't there a separate DIN CD player available as an option? If so, it
would likely plug in to the head unit. I suggest pulling it out and taking a
look.
DS

"PCB" <not (AT) this (DOT) time.mil> wrote

Yes, the Subaru head unit certainly is designed to work with a seperate
DIN CD player. The jack on the back of the stock head unit is circular
(I've already seen it).

What would be nice, is a product which can be plugged into that jack,
which gives an aux-in jack, similar to the product that's designed for
Honda head units.

If anyone knows of a product or way to get an aux-in with the Subaru
head unit, please share the info.
Thanks.


In article <ktJ_h.158798$6m4.48885@pd7urf1no>,
"DS" <davidscott (AT) shaw (DOT) ca> wrote:

"PCB" <not (AT) this (DOT) time.mil> wrote


My subie is older. It's a '92. The CD player is a separate unit that
plugs into a backside connector on the radio. If I wanted to go the
route of bringing out the connector to a box where I'd add accessible
connections, I'm not sure where to get a cable with that connector on
it. Well, I could find an old CD unit and snip off the cable
(www.abcofridleyautoparts.com) but they want $70 for an old CD player
that doesn't support all the latest formats. Hell, I can get the entire
radio for $25.
I toyed around with the idea of getting a flat 90-degree pre-made DIN
cable (so the cable comes out from the side instead of straight back
since I don't how much room there is behind the radio) that I could then
bring out to a plastic box in which I add whatever connector needed to
plug in other external equipment. Decided against it because it would
be too much work. I prefer finding simpler solutions, like a CD changer
with FM transmitter so all you have to do is tune your radio to a preset
channel to hear the CD music.

If you still want to go the route of bring out the backside DIN
connection from the radio, the pinout that I have for my '92 radio is:

Pin 1: NC
Pin 2: Line-In Right
Pin 3: NC
Pin 4: Line-In Left
Pin 5: Signal Gnd
Pin 6: CD Play (or Remote Amp In; send 12V to this to active amp for
remote device)
Pin 7: NC
Pin 8: Mute (input)
Pin 9: Acc Out (filtered power)
Pin 10: Batt Out (filtered power)
Pin 11: CD Stop (input)
Pin 12: NC
Pin 13: Gnd

I the article with this pinout by Googling on the part number on the
sticker on the back of the radio. I'd bet that http://www.digikey.com/
would have the part (i.e., cable with integral DIN connector) but it can
be tough finding it on their site unless you know specifically what you
are looking for.

On May 4, 2:09 am, PCB <n... (AT) this (DOT) time.mil> wrote:
I have a 1998 Legacy. I use a Sony car adapter (made for a Sony CD
discman). One end is a cassette-type unit which goes into the Subaru
tape player. The other end normally plugs into the Discman but can
also be plugged into other things that have a line-out jack. I'm not
sure this is what you're looking for but seems like it should allow
connection of other sources into the Subaru.

In article <1179173772.787818.49270 (AT) e65g2000hsc (DOT) googlegroups.com>,
Erasmus <dulieber69-grp2 (AT) yahoo (DOT) com> wrote:

Thanks, but no, what you have is a cassette tape adapter. I'm looking
for a solution that utilizes the CD port on the back of the head unit.
It would be a much cleaner, better-sounding solution than anything else.