How do the different engines (2.5 vs 2.5 turbo) feel when driving a
forrester or impreza?

Do they feel different right from the start (low RPM), or do they feel the
same until the RPM reaches, say, 3000?

A turbo wont engage really before 2300,2400 RPM depending on the
configuration.

Think of your vehicle's engine as an air pump that draws in air and fuel,
ignites the mixture--propelling the internal parts and expelling the hot
exhaust gases. Turbocharging, like a vacuum cleaner, brings in air,
compresses it, and changes the atmospheric pressure inside your vehicle's
engine.

A turbochargerd engine operates by the exhaust pressure exiting the engine,
causing an impeller to spin a wheel. The impeller is connected (by a shaft)
to a compressor; the compressor uses the energy from the impeller to spin
and compress incoming outside air and forces it through to the engine. An
actuator (attached to both the hot and cold side--the "hot" side is the cast
iron portion of the turbo, the "cold" side, the aluminum portion) regulates
boost pressure. The actuator can be "fooled" into thinking that the
atmospheric pressure is different that it actually is!

If you have the $ a Turbo car is really fun to drive and the extra power can
save your life (Personal experience ), "" Or kill you depending on your type
of Driving. If you like speeding a lot.... i would avoid a turbo car. ""

Im a (Speed lover and agressive driver ) I currently drive a OBW with a
2.5 @ 165 HP (5 Speed ) And it's a perfect vehicule for me. Fast enough
but not enough to be a Racing machine Like the Impreza WRX STI.

I would just like to improve the take off wich i guess is affected by the
AWD. But againg my previous car been a 230 HP VW Jetta Turbo (
Modified ) and a V6 4 Liter Jeep...

Subaru should have improve the Torque by 20-30 Lbs Higher than the HP. Im
sure it would make a big improvement


Pat



"peter" <nospam (AT) nospam (DOT) com> a écrit dans le message de news:
wDJve.10189$dY1.6409 (AT) trnddc06 (DOT) ..

peter wrote:
Why not just testdrive them?

I could not see myself ever going back to an N/A 4 cylinder subaru after
having 6 cyl and turbo 4 in the svx and forester XT. The 2.5 and 2.2 and
1.8 in non turbo form are just adequate. I have driven them all as we
have many different subarus in the family. You have to flog the hell out
of them to go anywhere fast. They are good engines, just weak for the
weight of the car they are trying to move.

The difference in power is stunning and the driveability up hills and
with a full load is awesome with the more powerfull turbo 4 and H-6 engines.

Tom Reingold wrote:

I get 20/27 in the svx with the 6 and about the same with the turbo
forester

Tom Reingold wrote:
About the same 20/25 for the turbo - a little worse than the svx H6 on
the highway due to the 4.44 axle.

The H6 does well on the highway mainly due to the 3.54 axle ratio. At
90mph it is only turning 3k rpms

"Tom Reingold" <tlr.usenet.0525 (AT) spambob (DOT) net> wrote

even though I'm heavily modified. Prior to being modded I was getting under
20 on a regular basis (wrx ej20) but since going to aftermarket engine
management (utec) I've been able to tune it for gas mileage, spirited
driving and outright drag racing/auto-x. IMHO the first mod anyone should
get (even if they NEVER race their wrx/sti) is a UTEC and get it on the dyno
so you can set it up for your needs.