| | Rating Thread /
Thread Starter | Last Post  | Replies | Views |
 |  | "Allen" <abanks1 (AT) columbus (DOT) rr.com> wrote
I had the same problem in my '93 Passat GLX. It would happen once the
engine got warm...
Mike Smith
|
07-03-2003 02:13 PM
Mike Smith  | 0 | 83 |
| | | I'm about to ditch my Jetta II for a new VR6 Jetta IV. I have some
14" snow tires that I would like to use on my new car. Will a 14" rim
fit over...
Brian
|
07-03-2003 02:06 PM
Kevin 'Sparty' Broderick | 3 | 47 |
| | | How nice!!! V6 4Motion has a top speed of 238km/h (148mph) probably on a
flat surface... Mine is not 4Motion so it should be lighter and would...
Kagan Gokbayrak
|
07-03-2003 01:09 PM
Mike Smith | 4 | 44 |
| | | Same here, I still liked it though. Now I'm looking for something that is 7700
lb and needs hauling to convince me and the bank I need this car....
Baudolino
|
07-03-2003 01:06 PM
Mike Smith | 3 | 41 |
| | | Only if it says so on the emissions sticker on the hood. sometimes youll
ahve an emissions sticker that says nothing about a cat. in this...
shane cummings
|
07-03-2003 12:18 PM
Andy Pronobis | 2 | 47 |
| | | Patrick,
I've tried replying a couple times to your email and it bounces even after
removing the obvious anti-spam stuff, so I hope you see this.
I...
MrEddy
|
07-03-2003 10:29 AM
MrEddy | 0 | 44 |
| | | I installed the correct NGK plugs (PFR6Q) last night. Checking the start
up after completing the installation,
the car idled just fine. I just talked...
el lobo
|
07-03-2003 10:15 AM
el lobo | 3 | 56 |
| | | Thanks Andy, you were correct. I bought a 30mm socket, but it was too
short. Then found they have a special socket for drive axle nuts at
auto...
spam@ham.com
|
07-03-2003 10:06 AM
spam@ham.com | 0 | 50 |
| | | Can anyone tell me if it is a straight swap from a Golf 2 1.3 (carby) to a
1.6 + 5 speed gearbox and still be able to use the drive axels from the...
Stephen Dale
|
07-03-2003 09:07 AM
Stephen Dale | 0 | 48 |
| | | read the link, the OZ gov't knocked it...
GTIce
|
07-03-2003 03:59 AM
John | 1 | 56 |
| | | The other day while 2 miles from my house my shift linkage rod popped off
while in 4th gear. I managed to get the car home but did rev the car up...
Type 3 Man
|
07-03-2003 12:14 AM
Type 3 Man | 0 | 44 |
| | | I replaced it tonight with a jobber VR, clickety click barba trick, no more
flash.
"The Admiral" <admiralkirk (AT) rocketmail (DOT) com> wrote
Mustangbrad
|
07-02-2003 10:56 PM
Mustangbrad | 1 | 63 |
| | | Hi all
Just had my drivers side bearings done and it cost £250, £30 part rest
was labour. This is v. expensive and now the off side front...
mp
|
07-02-2003 02:46 PM
mp | 0 | 43 |
| | | Hi Guys~
I hope someone might be able to clear something up for me? I was wondering
what a "Throttle Body" is, how it works, and how much one would...
Acquiesce
|
07-02-2003 12:30 PM
Acquiesce | 0 | 47 |
| | | I have recently bought a 1999 Passat TDI (110bhp), when I let it run up
through the gears 2nd accelerates smoothly all the way up to 4000 rpm,...
craig
|
07-02-2003 02:49 AM
Remco Meeder | 7 | 53 |
| | | out of an a2 jetta or golf, need the block and all of the kibble's in tact
(pistons,crank,oil pump,oil pan), the head doesn't matter. I'd take a...
Mustangbrad
|
07-02-2003 01:06 AM
Mustangbrad | 1 | 65 |
| | | Simple check if the cat is caca, drive it at night for a while and park it.
If the cat is glowing like a mofo, it is cat convertor...
shane cummings
|
07-02-2003 12:37 AM
Mustangbrad | 2 | 68 |
| | | Have a pinhole in my radiator plastic top header
How can I fix this with gleu ?? any suggestions ???
moony.
Lambert Moonen
|
07-01-2003 11:45 PM
Agingric37 | 4 | 100 |
| | | Mike,
You are on the right track! Same problem on my '94 GLS about 3 yrs back.
As I recall, (forgive me if I am using the wrong names for these...
DexAZ
|
07-01-2003 10:24 PM
DexAZ | 0 | 75 |
| | | I swear by it. Had it done at the dealer as the last thing before I drove
my '00 GTI GLX off the lot in 11/99. They had a guy who only does that...
joseph
|
07-01-2003 09:12 PM
joseph | 0 | 89 |
| | | Local tire shop aligned my 97 VR6 Wagon to 4cl Passat specs....should it
matter?
GJ Walsh
|
07-01-2003 05:59 PM
GJ Walsh | 0 | 120 |
 | | I have a 89 cabriolet w/1.8 and when I take off the gas cap it is under alot of
pressure, and after adding fuel the car stalls at idle for a while...
AlarmPro10
|
07-01-2003 05:36 PM
AlarmPro10 | 0 | 211 |
| | | High NO means it's probably running too hot. Ignition timing may be off, but
could also be a variety of more likely things... thermostat failing to...
Bob Hetzel
|
07-01-2003 04:12 PM
Bob Hetzel | 0 | 112 |
| | | On 3 Mar 2003 14:27:07 -0800, nascar211 (AT) hotmail (DOT) com (gshok) wrote:
I Have a 1996 vw jetta
I run 195/50/r15 with 15" wheels
I would...
gRiDiRoN
|
07-01-2003 01:39 PM
gRiDiRoN | 0 | 224 |
| | | My Jetta ('90 Carat) tends to rumble ***a little*** when I floor it....me
thinks that that is due to it being an automatic...
Peter Cressman
|
07-01-2003 09:47 AM
Babu | 2 | 87 |
| | | 1995 2l Jetta (Motronic).
Cold running is rough, I have lots of hesitation. Once warm, it still
feels like the engine is underpowered. If you deck...
Adam Oldham
|
07-01-2003 08:36 AM
dave | 1 | 88 |
| | | I have decided to take the next step, as far as the level of work that I
will do on my 2000 Jetta TDI, and purchase VAG-COM. On the Ross Tech...
Joe B
|
07-01-2003 08:26 AM
4Motion | 1 | 91 |
| | | Just wanted to let you guys know that the 2nd Annual Dubs Along the Rockies
is right around the corner. Here is a link to the site that will give...
Scott
|
07-01-2003 07:43 AM
Scott | 0 | 104 |
| | | It's not the GTI. Just ehe basic 97 Golf.
The 2 items you mentioned, would the problems with them be because the
battery was disconnected as it was?...
Carl Lucas
|
07-01-2003 05:47 AM
Carl Lucas | 2 | 81 |
| | | 97 VW Passat VR6 auto
I got a DTC
16725 - Camshaft Position Sensor (G40): Implausible Signal
35-00 - -
I checked the voltage at the CMP (#1 and #3...
Dave
|
06-30-2003 11:14 PM
Dave | 0 | 393 |
| | | hey all,
I have a 1997 (non DE) GTi-VR6, and every once in a while the airbag dummy
light flickers on. Sometimes it'll stay on for a few seconds,...
Dave A
|
06-30-2003 11:03 PM
Peter Cressman | 1 | 136 |
| | | I have a 2000 Jetta 1.8T.
My AC works fine, the only thing is when
I turn on the AC the rad fans do not go on.
Other than that the fans work fine,...
Alex
|
06-30-2003 09:53 PM
ALICIA LAU | 1 | 82 |
| | | I'm trying to figure out why the A/C on my 93 Fox is not working.
Firstly, all but the high settings on the fan don't work... so (according to
the...
99 C1V1C
|
06-30-2003 08:40 PM
99 C1V1C | 0 | 107 |
| | | Hi Adam,
I have tried the procedure mentionned in the manual on a 1996 Golf, and
it never worked either. I got pretty much the same results as...
E Tirschler
|
06-30-2003 06:49 PM
Adam Oldham | 1 | 100 |
| | | I have a load of engine parts for sale from a 1989 VW LT 35 TD, things like
the turbo, injection pump, injectors, head, radiator, manifolds,...
Gazz
|
06-30-2003 05:30 PM
Gazz | 0 | 215 |
| | | jimbehning (AT) mindspring (DOT) com wrote in message news:<1g5vfvoripaoucveejus71cb7o7rpj1s95 (AT) 4ax (DOT) com>...
Thanks for sharing your...
J. Michael Shifflette
|
06-30-2003 04:34 PM
Andy Pronobis | 1 | 107 |
| | | Thanks, Matt. I'll check it out (the site) and see if they've got anything
for me... I'll also drop by the dealer today and see the prices (I also...
MT
|
06-30-2003 03:28 PM
MT | 0 | 98 |
| | | OohAah wrote:
So why, then, is CA outlawing one of the most fuel-efficient cars on the
market?
--
Mike Smith
Mike Smith
|
06-30-2003 03:08 PM
Mike Smith | 1 | 83 |
