![]() | |
![]() |
| | Thread Tools | Search this Thread | Display Modes |
#1
| |||
| |||
|
#2
| |||
| |||
|
|
While we're on the subject of backup light switches, I was attempting to track down difficulties with mine yesterday. I have an '89 Cabriolet with the manual transmission, though, and at times it seems to be a "kit" with few clues (due to a previous owner...). The backup light switch connector I found upon the transaxle appears to have four male prongs in a row though after seeing a photograph on the carpartstogo site, I shall have to take a look at it and see if there may be a fifth prong arranged by itself. According to the part listing upon the carpartstogo site, this would indicate that it is an upshift indicating switch even though there is nothing in the instrument cluster that leads me to believe that the car has had an upshift indicator and there are only two wires (with no white nylon plastic plug housing, only female spade terminals that appear original and possibly once housed in a plug) that I have found leaving the wire bundle under the hood. The pair of wires I found and tested are definitely the backup lights, as well. As far as I know, neither the instrument cluster nor the engine/transaxle have been swapped out (but we know what assumptions cause, eh?) but the combination does seem odd. To make a long story a bit shorter, here are my questions: Is it possible to connect the backup lights to two of the prongs (I'm not worried about having an upshift indicator in the least) and, if so, which ones would apply? And, if this is not a solution, is it possible (or practical) to convert it to the two-prong switch? I suppose I could always connect a toggle switch to the two wires and post a "preflight checklist" on the dash, eh? ;-) (chuckle) Thanks in advance for any help! (By the way, I just went out and looked further at it and it is the five-prong, L-shaped switch.) -- Johnnie |
![]() |
| Thread Tools | Search this Thread |
| Display Modes | |
| |